INSTALLATION INSTRUCTIONS
INSTALLATION
B)SCREW FIXING METHOD
6.8Alternatively, this appliance can be secured back to the
fire place opening using the screws and rawl plugs provided. Place the firebox centrally in the opening and mark the positions of the 4 fixing holes. Drill the holes and insert the 4 rawl plugs. See diagram 7.
7
AR1158
6.9Offer the firebox into the opening and ensure that the gas supply pipe passes through the rubber seal.
6.10Refit the burner assembly and secure the 6 pozidriv screws. Connect the gas supply to the inlet connection on the burner unit and tighten. It may be necessary to support the inlet connection with another spanner whilst tightening this joint. See diagram 8.
8
AR1175
6.11Turn on the gas supply to the appliance and check for leaks. Light the fire and check all joints on the appliance for leaks.
6.12Remove the sealing screw from the inlet connection and connect a suitable “U” gauge manometer. Light the fire and turn to the maximum position, refer to the data badge and ensure that the running pressure is correct. If the pressure varies significantly from that on the data badge, this may indicate a supply problem and will require immediate attention.
6.13Turn the appliance off, disconnect the “U” gauge and replace the sealing screw. Relight the appliance and check the sealing screw for leaks.
7.ARRANGEMENT OF FUEL BED COMPONENTS
NOTE: CERAMIC PARTS ARE FRAGILE. THE SIDE AND REAR PANELS ARE REVERSIBLE. ONE SIDE IS PLAIN, THE OTHER SIDE IS REEDED. ASK THE CUSTOMER WHICH SIDE IS PREFERRED AT THIS STAGE.
ONLY USE THE CORRECT TYPE AND QUANTITY OF CERAMIC COMPONENTS. POINTS 7.1 TO 7.5 ARE COMMON TO ALL FUEL TYPES AND LAYOUTS.
7.1Position the burner cover gasket on the burner skin ensuring the holes align with the ports. Take care as the front
See diagram 9, arrow A.
9
AR1175
7.2Position the flame baffle centrally on the tray and ensure the stepped lower edge engages against the rear edge of the burner skin. See diagram 10.
10
AR1159
14