4 Using a 13 mm wrench undo all of the main burner orifices from the underside of the Display Panel. Place then aside form any other orifices included in the Natural Gas Conversion Kit.
5Using an approved thread sealant, replace the Main Burner Orifices with the NEW Natural Gas orifices supplied.
6Before reinstalling the Main Burner tubes, using a # 2 Phillips screwdriver, loosen the screw at the Air Shutter on the Main Burner. CLOSE the Air Shutter to a distance of 1/16” OPEN and retighten the Air Shutter adjustment screw.
7Reinstall the Main Burners ensuring that the Burner is properly placed over the Main
Burner orifice and reinstall the Main Burner screw on the firebox rear wall.
8Reinstall the Grease Pan, Upper Flavor Shields and Cooking Grids.
REAR BURNER.
1 Using a # 2 Phillips screwdriver undo the 4 screws that hold the Back Cover plate to the Inner Hood.
2Once the Cover has been removed use a 7 mm wrench to remove the Rear Burner Orifice from the Rear Burner.
3Install the new Rear Burner orifice using an
approved thread sealant.
Remove the 4 screws that hold the Back
Cover plate using a # 2 Phillips screwdriver
Undo the Rear Burner Orifice using a 7 mm wrench.
Reinstall the new Natural Gas Orifice using an approved thread sealant.
4 Reinstall the Rear Burner Cover Plate using the 4 screw previously removed.
NOTE: There is NO air adjustment required when converting the rear burner from Propane Gas to Natural Gas.
17