Side Burner

1Open the side burner lid and remove the grate over the burner head.

2Undo the 2 Phillips head screws that hold the Flame Thrower (burner ignition) and VERY Carefully move away from the burner Head.

3Undo the 3 screws that hold the Burner Head onto the Side Shelf base.

4Remove the 2 main orifices and place away from the Natural Gas conversion kit so the orifices will not get mixed up with the new orifices.

5Replace the 2 orifices using an approved thread sealant.

6Reinstall the Burner head using the 3 screws previously removed.

7Reinstall the Flame Thrower ensuring that the tip is properly placed inside the bottom of the Burner Head.

Burner Head screws X 3

Flame

Thrower screws X 2

Open the Side

Burner Lid and

Remove the

Grate above the

Burner head.

Carefully move the Flame Thrower (Burner ignition) away from the Burner Head.

Undo the 3 screws that hold the Burner Head to the base plate and carefully move Burner Head off of the 2 Side Burner orifices

Remove the 2 orifices from the Side Burner Valve and replace with the new Natural gas Orifices supplied in the Natural gas conversion kit

NOTE: These 2 orifices look the same. The smaller size orifice is to be installed in the center outlet of the Side Burner Gas Valve. And the larger orifice is to be installed on the right hand outlet of the Gas Valve.