Note: To monitor the tape while it is copying, adjust MASTER VOL- UME (or MASTER VOL – or MAS- TER VOL + on the remote control) to a comfortable listening level.
6.To stop copying, press STOP/ EJECT on both decks.
Notes:
•If the cassette tape in Deck 1 stops before the tape in Deck 2, the cassette tape in Deck 2 con- tinues to play at normal speed.
•If the cassette tape in Deck 2 stops before the tape in Deck 1, Deck 1 records silence. Press STOP/EJECT on Deck 1 when Deck 2 stops.
•If the original tape was recorded using Dolby NR, the copy also has Dolby NR, regardless of the posi- tion of the DOLBY NR switch. If the tape you copy does not have Dolby NR, you cannot add it to the tape you record.
Dubbing (Copying) CDs
1.Press CD.
2.If you want to record a program of CD selections, follow the steps in “Programming and Playing a Sequence” on Page 36 to pro- gram the CD playback.
3.Load a blank cassette tape, or one you want to record over, into Deck 1.
4.Press PLAY on Deck 1, wait for the blank tape to play past the tape leader (about 8 seconds), then press STOP/EJECT on Deck 1.
5.Select the CD you want to record from, then press PLAY/PAUSE on
the CD changer (or CD t |
| on the |
remote control) twice to pause the CD.
6.On Deck 1, press PAUSE then
RECORD. RECORD and PLAY on Deck 1 automatically lock down.
Caution: Do not force down RECORD. This can damage the recording mechanism.
7.Simultaneously press PAUSE on Deck 1 and PLAY/PAUSE on the
CD changer (or CD | t |
| on the |
remote control). The CD starts playing from Track 1 or at the beginning of a programmed sequence, and the cassette records until it reaches the end of the side.
8.When you finish recording, press STOP on the CD changer, then press STOP/EJECT on the tape deck.
Press STOP/EJECT again to open the cassette compartment and remove the cassette tape.
43