KitchenAid KBNS361T, KFRS271T If Converted to Natural Gas, To Install the 20 lb LP Gas Fuel Tank

Page 13

To Install the 20 lb LP Gas Fuel Tank:

1.Open cabinet doors.

2.Press the locking tab on the tank tray and pull out the tray.

A

A. Tank tray locking tab

3.Place the 20 lb LP gas fuel tank bottom collar into the mounting hole in the tank tray.

4.Tighten the locking screw against the bottom collar of the 20 lb LP gas fuel tank to secure.

A

BC

A.Locking screw

B.Mounting hole

C.Bottom collar

5.Screw the gas pressure regulator/hose assembly to the 20 lb LP gas fuel tank as shown.

B

A

A. 20 lb LP gas fuel tank

B. Gas pressure regulator/hose assembly

6.Turn on the gas supply. Wait a few minutes for gas to move through the gas line.

7.Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

8.Slide tank tray back into the cabinet and lock into place.

9.The igniter battery is not factory installed. A 1.5 volt “D” size alkaline battery is located in the accessory box on the grill grate. Install battery at this time following the instructions in the “Replacing the Igniter Battery” section.

10.Go to “Check and Adjust the Burners” section.

If Converted to Natural Gas

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor” gas supply line.

Securely tighten all gas connections.

Failure to do so can result in death, explosion, or fire.

This installation must conform with local codes and ordinances. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1, or CAN/CGA- B149.1 Natural Gas and Propane installation code.

Copies of the standards listed above may be obtained from:

CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts 02269

1.Make gas connections.

A combination of pipe fittings must be used to connect the grill to the existing gas line.

If local codes permit, use an outdoor flexible stainless steel tubing gas connector, design-certified by CSA International, to connect the grill to the rigid gas supply line. A ⁵⁄₈" diameter line is recommended. Using a wrench to tighten, connect the gas supply to the grill.

Use pipe-joint compound on all non-flared male threads. Do not kink or damage the flexible connector when moving the grill.

Pipe-joint compounds suitable for use with Natural gas must be used. Do not use TEFLON®† tape.

A

B

C

D

A. Grill gas pipe

B. New ANSI Z21.54 certified gray hose

C. Rear of grill

D. To Natural gas supply

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

13

Image 13
Contents Outdoor Grills Table DES Matières Table of ContentsYour safety and the safety of others are very important Outdoor Grill SafetyPage Important Safety Instructions Toolsand Parts Installation RequirementsLocation Requirements Style 1 Freestanding Outdoor GrillsCabinet Cutout Dimensions Product DimensionsBuilt-In OutdoorGrill Enclosure Built-In Outdoor GrillsElectrical Requirements Optional Access Doors Cutout WidthBuilt-in Outdoor Grill Enclosure Ventilation for LP Gas Grill Size Cutout WidthGas Connection Requirements Gas Supply RequirementsStyle1 Freestanding OutdoorGrills Local LP Gas Supply Style 2 -Built-In Outdoor GrillsNatural Gas Conversion Natural GasStyle 1 FreestandingOutdoor GrillInstallation Installation InstructionsLP Gas Conversion Using a Local LP Gas Supply LP Gas Conversion Using a 20 lb LP Gas Fuel TankRemove Packaging Material Inside the Grill Attach Cabinet Doors on some modelsMake Gas Connection LP GasIf Converted to Natural Gas To Install the 20 lb LP Gas Fuel TankPlug in Grill Style2- Built-In OutdoorGrill InstallationNatural Gas Use Single-prong plug Burner Flame Characteristics Check and Adjust theBurnersTo Adjust If Converting to LP GasLow Flame Adjustment Outdoor Grill USE Using YourOutdoor GrillControl Panel Inspect the LP Gas Fuel Tank Supply HosePrepare the Gas Supply UsingYourInfrared SearBurnerTurn the Gas Supply On Lighting the Grill and Infrared Sear BurnersManually lighting the side burner UsingYourSideBurnerLighting the Side Burner Optional Accessory UsingYourRotisserieTo Use Lighting the Rotisserie BurnerManually Lighting the Rotisserie Burner RotisserieCooking TipsTrussing Poultry for the Rotisserie On some models and as an accessory Using YourSmokerBoxHood Lights CookingMethods Tips for Outdoor GrillingTotal minutes Beef GrillingChartChicken Turkey Total minutes Fish and SeafoodFresh Vegetables GeneralCleaning Replacingthe Igniter BatteryCleaning Method Outdoor Grill CareWarming Shelf Infrared Sear Burners on some models TroubleshootingNothing will operate Accessories Assistance or ServiceTheU.S.A CanadaCall Kitchenaid Outdoor Product WarrantyPage Votre sécurité et celle des autres est très importante Sécurité DU Gril DextérieurAvertissement Conservez CES Instructions Exigences demplacement Exigences DinstallationOutillageetpièces Style 1 -Grils dextérieur autoportantsDimensions des ouverturesà découperdans Leplacard Dimensionsdu produitEnceinte du grildextérieur encastré Grils dextérieur encastrésPortes daccès facultatives* Largeur de louverture SpécificationsélectriquesTiroirs facultatifs Largeur Profondeur Spécifications delalimentation en gaz Méthode recommandée de mise à la terreDétendeur Test de pressurisation de la canalisation de gaz Puissance thermique des brûleurs en altitudeAlimentation par bouteille de propane Alimentation au propane par canalisation localeGaz naturel Conversion pour lalimentation au gaz naturelStyle 1 -Installation du gril dextérieur autoportant Instructions DinstallationInstallation de létagère latérale sur certains modèles Élimination des matériaux demballage à lintérieur du gril Installation des portes du placard sur certains modèlesRaccordement au gaz Gaz propaneAlimentation au gaz naturel après conversion Installation de la bouteille de propane de 20 lbBranchement du gril Style2- Installation du gril dextérieur EncastréAlimentation au gaz naturel Conversion pour lalimentation au propane Caractéristiques des flammes sur les brûleurs Contrôle et réglagedes brûleursRéglage pour le débit thermique minimum Processus de réglageUtilisation DU Gril Dextérieur Tableau de commandeUtilisation du grildextérieur Ouvrir larrivée de gaz Préparation de la source de gazAllumage du brûleur du gril et du brûleur à infrarouge Utilisation du brûleur latéral Utilisation dubrûleur à infrarougeAllumage du brûleur latéral Allumage manuel des brûleurs latérauxUtilisation du tournebroche Accessoire en optionUtilisation Allumage du brûleur du tournebroche Conseils de cuisson à l’aide du tournebrocheAllumage manuel du brûleur du tournebroche Utilisation du fumoir Sur certains modèles ou disponible comme accessoireLampes sous le capot Troussage de la volaille pour utilisation du tournebrocheMéthodesdecuisson Minutes au Tableau decuisson au grilTotal Bœuf Poisson et fruits de mer Total PouletDinde Légumes fraisEntretien DU Gril Dextérieur Remplacement delapile delallumeurChangementdelampouledéclairage Total Légumes frais à suivreMéthode de nettoyage NettoyagegénéralBrûleurs À Infrarouge sur certains modèles Brûleurs EN Forme DE UAccessoires Assistance OU ServiceDépannage Garantie Limitée DE UN AN Garantie DES Produits Pour Usage Extérieur KitchenaidComposer le 1-800-422-1230. Au Canada, composer le All rights reserved Tous droits réservés W10110724

KBNS271T, KFRS365T, KFRS271T, KBNS361T, KFRS361T specifications

The KitchenAid KFRS361T, KBNS361T, KFRS271T, KFRS365T, and KBNS271T models offer a blend of performance, style, and innovative features ideal for any modern kitchen. These refrigerator models exemplify KitchenAid's commitment to quality and user-friendly design, making them popular choices for home chefs and families alike.

One standout feature across these models is their advanced cooling technologies. With the Preserva Food Care System, each of these refrigerators ensures optimal freshness for your food by utilizing two distinct cooling systems that maintain ideal humidity levels and temperatures. This minimizes the mixing of odors and prolongs the shelf life of your ingredients.

The interior layout is designed for both function and convenience. Each model includes adjustable shelves, allowing users to customize their storage space according to their needs. The Slide-Away shelves offer added versatility, enabling users to make room for tall items with ease. Additionally, the Clear Humidity-Controlled Crispers help preserve fruits and vegetables by providing a climate-controlled environment.

Energy efficiency is another highlight, as these refrigerators are ENERGY STAR certified, meaning they consume less energy, which translates into lower utility bills. The integrated LED lighting illuminates the fridge’s interior excellently and is more energy-efficient than traditional lighting options.

Style is equally prioritized in these models. With a sleek stainless steel finish, they fit seamlessly into any kitchen decor, providing a modern aesthetic. The PrintShield Finish helps to resist fingerprints and smudges, keeping the exterior looking pristine with minimal effort.

The models also feature an In-Door-Ice System, which maximizes usable space inside the refrigerator by freeing up shelf space. The ice maker is conveniently located in the door, making it easy to access while ensuring more room for food storage.

Smart technology is also an option in some models, allowing for remote monitoring and temperature adjustments through smartphone applications. This feature promotes convenience and ensures food safety by alerting users to any temperature changes.

Overall, the KitchenAid KFRS361T, KBNS361T, KFRS271T, KFRS365T, and KBNS271T models combine innovative technology with stylish design, making them a perfect addition to any kitchen looking for enhanced functionality and modern elegance. These refrigerators epitomize KitchenAid's focus on quality and reliability, catering to the needs of discerning home cooks.