Desa (V) CB36(N GAS Supply and Piping, High Altitude Installation, Check GAS Type

Page 12

11

INSTALLATING OPTIONAL CONTROLS (Cont.)

Installing Optional Wireless Remote Control - Model WRC

HIGH ALTITUDE INSTALLATION

GAS SUPPLY AND PIPING

Check Gas Type

Installing Gas Piping to Fireplace

INSTALLING OPTIONAL CONTROLS

Continued

INSTALLING OPTIONAL WIRELESS REMOTE CONTROL - MODEL WRC (Electronic Ignition)

Installing and Activating the Remote Receiver

1.Open bottom louver and locate the plug receptacle. The plug receptacle is located either on the right or left side of cabinet.

2.The WRC model receiver does not require a battery. The re- ceiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 20).

3.Activate the remote handset battery by removing the insulat- ing tab on the back of the handset (see Figure 21). The battery is included pre-installed.

4.Once the battery is activated the unit is ready to use.

5.Replace the bottom louver panel.

When installing a non-high altitude fireplace at an elevation above 2000 feet (610 m) (in the USA), you may need to decrease the input rating by changing the existing burner orifice to a smaller size. Reduce input 4% for each 1000 feet (305 m) above sea level. Check with your local gas company for proper derate procedure and orifice size.

When installing this fireplace in Canada at an elevation above 4500 feet (1372 m), Check with local or provincial code authorities.

Consult your local gas company to help determine the proper orifice for your location.

For assistance with any high altitude installation contact DESA’s Customer Service Department at 1-866-672-6040.

GAS SUPPLY AND PIPING

CHECK GAS TYPE

Fireplace Receptacle

Remote Control Receiver

Use proper gas type for the fireplace unit you are installing. If your gas supply is not correct, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gastypeortopurchasegasconversionkit(seeAccessories,page33).

INSTALLING GAS PIPING TO FIREPLACE

Extension Cord

Ignition

Module Plug

Figure 20 - Connecting WRC Remote Control Electronic

Battery Cover

12 Volt Battery

Back of

Pull to Remove

Handset

Insulation Tab

Figure 21 - Installing Battery into Back of Handset

HIGH ALTITUDE INSTALLATION

Your DESA direct-vent fireplace has been tested and approved in the USA for elevations from 0-2000 feet (610 m) and in Canada at elevations from 0-4500 feet (1372 m).

WARNING: A qualified service person must con- nect fireplace to gas supply. Follow all local codes.

CAUTION: For propane/LP units, never connect fireplace directly to the propane/LP supply. This heater requires an external regulator (not supplied). Install the external regulator between the fireplace and propane/LP supply.

External

Propane/LP

Regulator

Supply Tank

Vent

Pointing

Down

Figure 22 - External Regulator with Vent Pointing Down (Pro- pane/LP Only)

www.desatech.com

117437-01

Page 11 Page 13
Image 12
Page 11 Page 13
Contents OWNER’S Operation and Installation Manual Inch B-VENT Decorative GAS Fireplaces For Your SafetyFor Your Safety What to do if YOU Smell GAS Save this manual for future referencePage Table of Contents Safety InformationProduct Identification Local CodesProduct Features PRE-INSTALLATION PreparationPRE-INSTALATION Preparation ClearancesFraming and Finishing Unit Dimensions Mantel ClearancesInstallation Precautions Venting Installation Typical B-Vent ConfigurationVenting Installation Checking for Proper VentingWiring Diagrams Electronic Ignition Wiring DiagramElectrical Supply Connection Installing Optional Controls Installing Optional Wall Mount Switch GWMS2Receiver Volt Alkaline Battery Terminal Wires Battery Clip Installing Remote ReceiverHigh Altitude Installation Installing GAS Piping to FireplaceGAS Supply and Piping Check GAS TypeInstallation Items Needed Natural FromChecking GAS Connections Test Pressures In Excess of 1/2 Psig 3.5 kPaTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Equipment Shutoff Open Valve ClosedHearth Access and Assembly Removing Lower Louver Access PanelRemoving Top Louver Trim Panel Removing/Replacing Glass DoorInstalling Logs and Glowing Embers Applying Ember MaterialFor Your Safety Read Before Lighting Manual Lighting ProcedureOperating Fireplace Lighting InstructionsOptional Wireless Remote Operation Operating Fireplace Electronic Ignition SystemOperating Optional GWMS2 ON/OFF Wall Mounted Switch Optional HAND-HELD Remote OperationON/OFF Series Model HRC100 Pilot Assembly AIR Adjustment SettingInspecting Burners Burner Flame PatternCleaning and Maintenance Glass DoorPilot and Burners LogsTroubleshooting Needle, or similar object toPilot unit Or cycles during operation Gas leak. See Warning statement Ment Parts, Gas leak. See Warning statement at Replacement Parts Service Hints Technical ServiceSpecifications Parts Under WarrantyIllustrated Parts Breakdown Parts List KEYVCB36N VCB36NEBurner Assembly for Models VCB36N, VCB36P Description QTY Burner Assembly for Models VCB36NE, VCB36PE KEY VCB36NE VCB36PE Description QTY Accessories Remote Control KIT WRC SeriesOWNER’S Registration Form Industrial Drive Box Bowling Green, KY 117437-01 117437-01 Page Keep this Warranty Model Serial No Date PurchasedIndustrial Drive P.O. Box
Top Page Image Contents