SAFETY INFORMATION
3PRODUCT IDENTIFICATION LOCAL CODES
SAFETY INFORMATION
Continued
5. | This fireplace reaches high temperatures, Keep children and |
| adults away from hot surfaces to avoid burns or clothing igni- |
| tion. Fireplace will remain hot for a time after shutdown. Al- |
| low surfaces to cool before touching. |
6. | Carefully supervise young children when they are in the room |
| with fireplace. |
7. | Do not modify this fireplace under any circumstances. Any |
PRODUCT IDENTIFICATION
4“
Flue Collar
| parts removed for servicing must be replaced prior to operat- |
| ing fireplace. |
8. | Turn fireplace off and let cool before servicing, installing, or |
| repairing. Only a qualified service person should install, ser- |
| vice or repair this fireplace. Have fireplace inspected annu- |
| ally by a qualified service person. |
9. | You must keep control compartments, burners, and circulat- |
| ing air passages clean. More frequent cleaning may be needed |
| due to excessive lint and dust from carpeting, bedding mate- |
| rial, etc. Turn off the gas valve and pilot light before cleaning |
| fireplace. |
10. | Have venting system inspected annually by a qualified service |
| person. If needed, have venting system cleaned or repaired. |
| See Cleaning and Maintenance, page 20. |
11. | Keep the area around your fireplace clear of combustible ma- |
| terials, gasoline, and other flammable vapor and liquids. Do |
| not run fireplace where these are used or stored. Do not place |
| items such as clothing or decorations on or around fireplace. |
12. | Do not use this fireplace to cook food or burn paper or other |
| objects. |
Louver
Panel
Top
Glass
Door
Assembly
Louver 
Panel
Bottom
Junction Box
(Electronic
Ignition Only)
Nailing
Flange
Log
Set
Ember
Tray
Outside Air
Kit Barometric
Damper
Control Valve Piezo Ignitor with Optional Remote and Blower Control Mount
Figure 1 - B-Vent Fireplace
13.Do not use any solid fuels (wood, coal, paper, cardboard, etc.) in this fireplace. Use only the gas type indicated on the nameplate.
14.This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electric Code, ANSI/NFPA 70, or the Ca- nadian Electric Code, CSA C22.1.
15.Do not use fireplace if any part has been exposed to or under water. Immediately call a qualified service person to arrange for replacement of the unit.
16.Do not operate fireplace if any log is broken or missing.
17.Do not use a blower insert, heat exchanger insert, or other ac- cessory not approved for use with this fireplace.
18.Do not operate fireplace with glass door removed, cracked, or broken.
19.Provide adequate clearances around air openings.
NOTICE: This product is intended only as a supple- ment to your central heating system and is not to be installed as a primary source of heat. You may use this product for emergency heating during a power outage.
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the current National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
www.desatech.com |