Desa VSGF33PRC, VSGF33NRC installation manual Installation Clearances, Example

Page 9

Installation

Continued

Rail

Hood

Screw

Figure 5 - Installing Hood

Assembling and attaching OPTIONAL perimeter trim (Included with Mantel Accessory)

IMPORTANT: If you are recessing the firebox in a wall, do not attach trim at this time. See Built-In Fireplace Installation, page 11.

Note: The instructions below show assembling and attaching trim to fireplace.

1.Remove packaging from three pieces of trim.

2.Locate four screws, two adjusting plates with set screws, and two shims in the hard- ware packet.

3.Align shim under adjusting plate as shown in Figure 6.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 6).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 6).

6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other side.

8.Tighten trim hanging screws (#10 x 6.25 shoul- der) into holes in cabinets. Place the assembled trim onto fireplace cabinet.Align hanging notches on trim with hanging screws on side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over hanging screws.

 

Set Screws

Side Trim Adjusting

Top

Plate

Trim

Mitered

Shim Edge

Mitered Slot

Slot Edge

Figure 6 - Assembling Perimeter Trim

Trim

Hanging

Screws

Hanging Notches on Trim

Assembled

Trim

Figure 7 - Attaching Perimeter Trim to

Fireplace

INSTALLATION CLEARANCES

WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceiling, and adjoining wall.

Carefully follow the instructions below. This will ensure safe installation.

MinimumClearances ForSideCombustible

Material, Side Wall, and Ceiling

A. Clearances from the side of the fireplace cabinet to any combustible material and wall should follow diagram in Figure 8.

Example: The face of a mantel, bookshelf, etc. is made of combustible material and protrudes 3 1/2" from the wall. This combus- tible material must be 4" from the side of the fireplace opening (see Figure 8).

B. Clearances from the top of the fireplace opening to the ceiling should not be less than 42".

MINIMUM CLEARANCE TO

COMBUSTIBLE MATERIALS

Top

Left and

Bottom

 

Right Sides

and Rear

0"

16"

0"

 

Example

 

 

 

*

*Minimum 16" from SideWall

Figure 8 - Minimum Clearance for

Combustible to Wall

119304-01Awww.desatech.com

Image 9
Contents Remote-ready fireplace System VSGF33PRC and VSGF33NRCTable of Contents Safety Information Local Codes Product IdentificationAccessory Product FeaturesUnpacking Air For Combustion VentilationAIR for Combustion Ventilation Providing Adequate VentilationDetermining FRESH-AIR Flow for Fireplace Location Ventilation AIR Ventilation Air From Inside BuildingVentilation Air From Outdoors Installing Hood InstallationCheck GAS Type Electrical HookupExample Installation ClearancesInstalling Gas Piping to Fireplace Location, Conventional Fireplace InstallationActual Framing Height Built-In Fireplace InstallationFront Width DepthInstalling Gas Piping to Fireplace Location Mantel Clearances for Built-In InstallationInstallation Items Needed Propane/LP Vent Pointing DownConnecting Fireplace to Gas Supply Checking GAS ConnectionsNatural Gas Test Pressures Equal To or Less Than Psig 3.5 kPa Pressure Testing Fireplace Gas ConnectionsInstalling Bottom Logs Installing LogsOperating Fireplace For Your Safety Read Before LightingLighting InstructionsTo Turn OFF GAS To Appliance Manual Lighting ProcedureOpTIONAL Hand-Held Remote OperationThermostat Model HRC200 On/Off Model HRC100Optional Blower Operation Inspecting BurnersPilot Flame Pattern Main burnerCleaning Maintenance Inspecting BurnersBurner Injector Holder and Pilot Air Inlet Hole Wiring Diagram Cleaning MaintenanceSpecifications LogsObserved Problem Possible Cause Remedy TroubleshootingDiagram, TroubleshootingStalling Logs, Statement above Gas leak. See WarningService Hints Replacement PartsTechnical Service Parts Under WarrantyIllustrated Parts Breakdown Log Base Assembly Models VSGF33NRC and VSGF33PRCParts List Fireplace mOdels VSGF33NRC and VSGF33PRC Illustrated Parts BreakdownParts List Receiver and HAND-HELD Thermostat Remote Control KIT HRC200 AccessoriesReceiver and HAND-HELD Remote Control KIT HRC100 Equipment Shutoff Valve GA5010Accessories WALL-MOUNT ON/OFF SwitchWALL-MOUNT Thermostat 119304-01A 119304-01A Warranty Information Keep this WarrantyLimited Warranty VENT-FREE GAS Fireplace