Char-Broil 463257010 Leak Testing Valves, Hose and Regulator, Turn all grill control knobs to OFF

Page 10

Hold coupling nut and regulator as shown for proper connection to LP cylinder valve.

6.Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools.

NOTE:

If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the

connection, do not use this regulator!

DANGER

•Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.

WARNING

•Outdoor gas appliance is not intended to be installed in or on a boat.

•Outdoor gas appliance is not intended to be installed in or on an RV.

•Never attempt to attach this grill to the self-contained LP gas system of a camper trailer or motor home.

•Do not use grill until leak-tested.

•If a leak is detected at any time, STOP and call the fire department.

•If you cannot stop a gas leak, immediately close LPcylinder valve and call LP gas supplier or your fire department!

10

Leak Testing Valves, Hose and Regulator

1.Turn all grill control knobs to OFF.

2.Be sure regulator is tightly connected to LP cylinder.

3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding.

4.Brush soapy solution onto areas circled below, or other similar fittings on your grill.

 

 

 

 

 

 

 

 

NOTE: Your grill

 

 

NOTE: Sideburner

 

may NOT be

 

 

shelf fascia not

 

equipped with a

 

 

shown for clarity.

 

sideburner.

 

 

 

 

 

 

5.If “growing” bubbles appear, there is a leak. Close LP cylinder valve immediately and retighten connections. If leaks

cannot be stopped do not try to repair. Call for replacement

parts.

6.Always close LP cylinder valve after performing leak test by turning hand wheel clockwise.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionFirst Time Use TemperatureGrilling Guide Getting Started Lava Rock / BriquettesDirect Cooking Food SafetyGrilling Guide Grilling Indirect CookingUsda Recommended Safe Minimum Internal Temperatures Grilling Guide Tips & TricksGrilling Guide Cleaning Your Grill LP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UL listed Overfill ProtectionUseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderLimited Warranty All Other Parts Year from date of purchaseParts List Not PicturedParts Diagram Rear AssemblyFront 20x1/2 screws, 7mm lock washers,Grill head Regulator hose Upper back panel Holes on fascia to Attach bezel Holes on fascia to Attach valve bracketFully tighten lower screws on upper back panel Sideburner valve, shown C Self-tapping screw Wire Heat shieldClarity of illustration Cylinder screw at rear of cart AA Battery Electronic Ignition Cap Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA
Top Page Image Contents