Char-Broil 463257010 manual Upper back panel

Page 19

5

On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in lower holes, using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer on each side. Do not fully tighten screws until side shelf installation is complete in later steps.

1/4-20x1½”	7mm lock	7mm flat
screw	washer	washer

Upper back panel

6

Insert flange on right side shelf into side shelf brackets on side of firebox.
Attach right side shelf using four 1/4”-20x3/4”screws, 7mm lock washers,
7mm flat washers, 1/4” nuts, shown A. Attach rear of shelf using one
1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer in lower hole, shown B.
Attach front of shelf and fascia using one #8x3/8” self-tapping screw and large
flat washer, shown C.	A
	A
B

7mm flat		1/4-20x1½”
7mm flat			screw
washer	7mm lock		screw			1/4-20x3/4”
	washer					1/4-20x3/4”
						screw
						screw
						7mm flat
					1/4”nut	7mm lock washer
					1/4”nut	washer

Bracket

C

#8x3/8” self-tapping screw

Fascia, right side shelf

Large flat washer

19

Image 19

Contents Date Purchased Estimated assembly time 30 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsLava Rock / Briquettes TemperatureGrilling Guide Getting Started First Time UseIndirect Cooking Food SafetyGrilling Guide Grilling Direct CookingGrilling Guide Tips & Tricks Usda Recommended Safe Minimum Internal TemperaturesGrilling Guide Cleaning Your Grill UL listed Overfill Protection USE and CareLP Liquefied Petroleum Gas LP Cylinder FillingUseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF Open lid during lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lightingBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingTurn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill Very Important Burner tubes must reengage valveAll Other Parts Year from date of purchase Limited WarrantyNot Pictured Parts ListParts Diagram 20x1/2 screws, 7mm lock washers, AssemblyFront RearGrill head Regulator hose Upper back panel Holes on fascia to Attach bezel Holes on fascia to Attach valve bracketFully tighten lower screws on upper back panel Sideburner valve, shown C Self-tapping screw Heat shield WireClarity of illustration Cylinder screw at rear of cart AA Battery Electronic Ignition Cap Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Warranty Registration Department Box Columbus, GA