Char-Broil 463257010 Holes on fascia to Attach valve bracket, Holes on fascia to Attach bezel

7

Insert flange on left side shelf into side shelf brackets on side of firebox.

Attach left side shelf using four 1/4-20x3/4”screws, 7mm lock washers, 7mm flat washers, 1/4” nuts, shown A. Attach rear of shelf using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer in lower hole, shown B. Attach front of shelf and fascia using one #8x3/8” self-tapping screw and large flat washer, shown C.

Fully tighten lower screws on upper back panel.

A

1/4-20x3/4”
screw
7mm flat washer	1/4”nut

7mm lock washer

C

#8x3/8” self-tapping screw

large flat washer

B

			Flange
			into
1/4-20x1½”	7mm lock	7mm flat
			Brackets
		washer
screw

Left sideburner shelf

Bracket

Fascia, left sideburner shelf

8

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right

holes on fascia to

attach valve bracket

Screws and Washers removed from valve bracket

Install bezel with “OFF” at top.

Sideburner fascia

Sideburner valve bracket

Note: Use upper and lower

holes on fascia to

attach bezel

Control knob #8-32x3/8” screw

4mm

lock washer

Control knob bezel

Valve stem

20