Char-Broil 463257010 manual Assembly, Front, Rear, 20x1/2 screws, 7mm lock washers

Page 17

ASSEMBLY

1

Attach the two locking casters at the rear of the bottom shelf and the two fixed casters at the front.

Use the provided caster wrench to fully tighten casters.

Fixed caster

Locking caster

Front

Bottom shelf

Rear

2	Attach side panels to bottom shelf using three
	1/4-20x1/2”screws, 7mm lock washers, and

7mm flat washers per panel.

IMPORTANT: Panel with large hole must be on left side of bottom shelf.

Left side panel (with large hole)

Make sure side panels are pushed as far to the rear of bottom shelf as possible before fully tightening screws.

1/4-20x1/2” screw

7mm lock washer 7mm flat washer

Right side panel

13

Image 17

Contents Date Purchased Estimated assembly time 30 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsGrilling Guide Getting Started TemperatureFirst Time Use Lava Rock / BriquettesGrilling Guide Grilling Food SafetyDirect Cooking Indirect CookingGrilling Guide Tips & Tricks Usda Recommended Safe Minimum Internal TemperaturesGrilling Guide Cleaning Your Grill LP Liquefied Petroleum Gas USE and CareLP Cylinder Filling UL listed Overfill ProtectionLP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lightingSideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame CheckStoring Your Grill Cleaning the Burner AssemblyVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderAll Other Parts Year from date of purchase Limited WarrantyNot Pictured Parts ListParts Diagram Front AssemblyRear 20x1/2 screws, 7mm lock washers,Grill head Regulator hose Upper back panel Fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracketHoles on fascia to Attach bezel Sideburner valve, shown C Self-tapping screw Heat shield WireClarity of illustration Cylinder screw at rear of cart AA Battery Electronic Ignition Cap Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Warranty Registration Department Box Columbus, GA