Char-Broil 463257010 manual Self-tapping screw

Page 22

11

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

Note: some parts omitted for clarity of illustration

Door

Hinge Pin

Front brace	7mm flat	7mm lock	1/4-20x1½”
	washer	washer	screw

12

Inside of cart, insert left and right grease tray rails into slots beneath grease tray opening in upper back panel, shown A. Attach right and left rails under front brace with two #8x3/8” self-tapping screws, shown B.

Note: some parts omitted for clarity of illustration

A

B

Cart lower back panel

#8x3/8”

Right rail

self-tapping screw

Left rail

Right rail

Left rail

Grease tray opening

22

Image 22

Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionFirst Time Use TemperatureGrilling Guide Getting Started Lava Rock / BriquettesDirect Cooking Food SafetyGrilling Guide Grilling Indirect CookingUsda Recommended Safe Minimum Internal Temperatures Grilling Guide Tips & TricksGrilling Guide Cleaning Your Grill LP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UL listed Overfill ProtectionUseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderLimited Warranty All Other Parts Year from date of purchaseParts List Not PicturedParts Diagram Rear AssemblyFront 20x1/2 screws, 7mm lock washers,Grill head Regulator hose Upper back panel Holes on fascia to Attach bezel Holes on fascia to Attach valve bracketFully tighten lower screws on upper back panel Sideburner valve, shown C Self-tapping screw Wire Heat shieldClarity of illustration Cylinder screw at rear of cart AA Battery Electronic Ignition Cap Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA