13
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door.
Right door
Left door
PRESS
Top of door
Hinge pin on bottom of door
14
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart right side panel with the nut and cap, shown A.
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition Module.Total (5) connections.
Connect the two wires(A and B) from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as A, B. Do not untie the wires while attaching.
A
Electronic |
|
ignition module | Right side panel |
Heat shield | Nut | Cap |
3 |
|
|
4 |
| A |
| 1 | |
5 |
| |
| 2 | |
| B | |
|
|
Wire
23