Coleman 9949A manual Installing 1 lb. Propane Cylinder

Installing 1 lb. Propane Cylinder

NOTE: Your 9949 Series grill is set up from the factory to use a 1 lb. disposable propane cylinder.

WARNING

Only cylinders marked “Propane” must be used.

WARNING

This procedure MUST be performed OUTDOORS only! Read and follow the directions on the cylinder.

DANGER

rNEVER store a spare L.P. gas supply cylinder under the grill body or inside the grill enclosure or in the vicinity of any heat producing appliance.

Failure to follow this information exactly could result in an explosion and/or fire causing death or serious injury.

CAUTION

Tighten by hand only. DO NOT use tools.

■Before attaching propane cylinder make sure burner valves are in the

OFF position. (Fig. 15)

Fig. 15

■ Remove plastic cap from	Fig. 16
top of propane cylinder
and screw cylinder into
regulator hand tight.
(Fig. 16)

Fig. 18

■Never operate grill with propane cylinder in an inverted position. (Fig. 20)

■To open lid, move lever to OPEN position and lift up. (Fig. 21)

■Place a grill grate, griddle, or stove ring over each burner. (Fig. 22, 23, and 24)

Grill Grate
	Griddle

Fig. 23

Fig. 19

Fig. 20

OPEN	LOCK
LOW
	LOW
HIGH/LIGHT	OFF
	HIGH/LIGHT

Fig. 21

Fig. 22

Stove Ring

Fig. 24

■ Press on cylinder support on back of grill and swing out. (Fig. 17)

■Screw regulator into grill hand tight. (Fig. 18)

■ Place cylinder into cylinder support. (Fig. 19)

Fig. 17

WARNING

DO NOT operate the grill with side tables in storage position. Damage will occur and void the warranty.

■To extend side tables,

grasp hold of side tables on bottom of grill and slide out until fully extended. (Fig. 25)

Fig. 25

English-6