Install Ignitor Battery
[] Unscrew Ignitor Cap from Control Panel.
[] Place supplied AA battery into the Ignitor Slot with positive pole facing you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Main Burners Electrode Check
Perform this Electrode Check with the
assistance of another person.
This test will ensure that the Spark Electrode Tips are properly positioned so your grill lights easily and properly.
Spark Gap Gas Collector Box
ctrode Tip
[] Be sure all Control Knobs are set to "OFF" and open the Grill Lid.
[] Have your assistant stand behind to the right of the grill and look toward the front of the grill bowl. Never put your face inside the Grill Bowl.
[] Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should see a blue spark within each Gas
Collector Box. If a spark is present the
Electrode Tips are properly positioned. [] If no spark is seen, the Spark Gap
needs to be adjusted as follows:
•Using an adjustable wrench, loosen the Inside Nut until the Gas Collector Box can
be turned upward.
•If the gap between the Spark Elec- trode Tip and Receiver is more than 3/16" use long nose pliers to gently squeeze the Gas Collector Box to narrow gap.
•Return the Gas Collector Box to its original position, secure the Inside Nut and try the Electrode Check again. If no "clicking" sound is heard:
•AA Battery may be installed back- wards.
•Electric wires may be loose. Remove the AA Battery and inspect the Ignitor Junction Box found behind the Control
Panel and reconnect any loose wires.
Side Burner and Rotisserie Burner Electrode Check
[] Open side burner lid. Remove plastic shipping band from burner and pot support.
[] Turn side burner Control Knob to IGN and push in. Look for spark between tip of electrode and burner.
[] Open Grill Lid. Turn rotisserie burner Control Knob to IGN and push in. Look
for spark between tip of electrode and burner.
[] If you don't see a spark from side or rotisserie burner electrode, adjust gap between electrode and burner surface to 3/16 in.
,gnito -
Cap Spring
AA Battery
Ignitor Slot
Install Cooking Components
[] Place the Heat Diffusers on lower ledge above Burners.
[] Place Cooking Grids on bowl ledge.
[] Place the Secondary Cooking Rack into the slots on Grill Bowl Side Panels.
Secondary Cooking Rack
Cooking Grids
Heat
Slots for Secondary
Cooking Rack
Model141.16315800
When you have finished assembling your grill be sure that all screws are tightened for safe operation of your grill.
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion that could cause serious bodily injury, death or property damage.
15