Before Using Your Rotisserie, Important Safeguards

ROTISSERIE BURNER IGNITION & USAGE

BEFORE USING YOUR ROTISSERIE

Note: Before using your rotisserie, measure your food at the widest point. If it exceeds 9½" (241.8mm), it is too large to fit the rotisserie. If it is too large, food can be prepared using a roast holder and the Indirect Cooking Method.

Important Safeguards

mWARNINGS

mRead all instructions before using your rotisserie.

mThis rotisserie is for outdoor use only.

mRemove motor and store in a dry place when not in use.

mDo not touch hot surfaces. Use barbecue mitts.

mThis rotisserie is not for use by children.

mTo protect against electrical hazards do not immerse cord, plugs, or motor in water or other liquids.

mUnplug the motor from outlet when not in use or before cleaning.

mDo not use rotisserie for other than intended use.

mMake sure motor is off before placing it on the motor bracket.

mDo not operate the rotisserie motor with a damaged cord or plug.

mDo not operate the rotisserie motor if it should malfunction.

mThe rotisserie motor is equipped with a three prong (grounding) power cord for your protection against shock hazard.

mThe power cord should be plugged directly into a properly grounded three prong receptacle. If use of an extension cord is required, be sure that it is a minimum 16 AWG (1.3mm), 3-wire, well insulated cord marked for OUTDOOR USE ONLY and properly grounded.

mWhen using an extension cord, make sure it is not in contact with a hot or sharp surface.

mOutdoor extension cords should be marked with the letters “W-A” and a tag stating “Suitable for use with outdoor appliances”.

mDo not cut or remove the grounding prong from the rotisserie motor power cord.

mDo not let cord hang over any sharp edge or hot surface.

mTo reduce the risk of electric shock, keep extension cord connection dry and off the ground.

mA short power cord is supplied to reduce the risk of tripping over the cord. Extension cords may be used, but caution must be taken to prevent tripping over the cord.

mIn absence of local codes the rotisserie motor must be grounded electrically in accordance with the National Electric Code, ANSI / NFPA 70, or Canadian Electrical Code, CSA C22.1. ◆

OPERATING THE ROTISSERIE

mWARNING: Setup up the rotisserie with food before lighting rotisserie burner.

A)To set up rotisserie motor, push the button on the retractable rotisserie panel (1).. Pull rotisserie panel upwards.. Push locking tab (2) until it snaps into place..

B)Remove power cord and plug into power source..

mCAUTION: Do not route rotisserie motor power cord through the retractable rotisserie opening in the side table.

mCAUTION: Inspect power cord before each use. If cord is damaged, do not use. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

C)Slide one of the spit forks towards the right side of the rotisserie shaft, making sure that the spikes face to the left and the fork screw faces down (3)..

D)Push the rotisserie shaft through the center of the food.. Insert the tines of both spit forks into the food.. The food should be centered on the shaft.. Tighten the spit fork screw (4)..

E)Slide another spit fork onto the rotisserie shaft, making sure that the spikes face to the right and the fork screw faces up.. Insert the tines of both spit forks into the food.. Tighten the spit fork screw (5)..

2 1