Weber 900 owner manual Assemble wheel frame, Assemble top frame

Page 10

Step 2

Assemble wheel frame

You will need: wheel frame, two wheels, two wheel hubcaps, hammer and a block of wood.

Set one end of wheel frame on the block of wood (or other hard, protected surface). Put one wheel on axle, WEBER side facing up, and tap on one hubcap. Figure 1.

Repeat with other wheel and hubcap.

B

W

E

E

W

 

B

Step 3

Assemble top frame

You will need: left frame, right frame, two 1/4-20 x 1/2 inch bolts, two nylon washers and a 7/16 inch wrench.

Note - Work on carpeted area (on grass or one of the boxes) to protect the finish during frame assembly.

Lay the leg pieces as shown so the leg tabs point up. Figure 2.

Slip the two frame pieces together with the tabs inside. Figure 2 (a). Slip washers on bolts, insert bolts as shown and tighten. Figure 2 (b). (If you try to insert a bolt and there are no holes, you have the left frame turned the wrong way. Turn the left frame around.)

Frame tabs

Figure 1

(a)

 

Leg tabs

Right frame

Left frame

(b)

Figure 2

10

Image 10
Contents Natural Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaGas supply testing StorageCheck package contents AssemblyStep Page Check contents of hardware packs Assemble wheel frame Assemble top frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install gas supply Install manifold bracketInstall frame connector General Specifications for PipingGas line piping Typical natural gas supply installation. FigureTest connections Check that all burner valves are off Install igniterConnect flexible hose to manifold Check for gas leaks Install Flavorizer Bars and Cooking Grates Install the bottom trayInstall Lid Add tool holders, control panel and burner control knobsInstall swing table MWARNING The load limit for the swing table is 30 poundsComplete accessory installation Lighting To ExtinguishManual Lighting Storage and/or Nonuse Periodic CleaningCooking PreheatingCast Iron Cooking Grates Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking MCAUTION Do not enlarge the burner ports when cleaning General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High position Problem Check Cure Burners burn with a yellow or orangeFlame, in conjunction with the smell of gas Experiencing flare-ups11-12 53 46-48 Parts List Final Word Thanks