Weber 900 owner manual Add cooking box

Page 12

Step 7

Add cooking box

You will need: frame assembly, cooking box assembly, 1/4-20 keps nut, 1/4-20 x 2 inch bolt, pliers and a 7/16 inch wrench.

Set the cooking box in the frame so the burner tubes are under the frame brace. Figure 6.

Burner tubes

Frame brace

Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment:

a)Do the valves fit into the ends of the burners? Figure 8 (a).

b)Are the ends of the burners under the washers at the left rear and left front of the cooking box? The screws are only guides. Do not tighten. Figure 8 (b).

c)Are the wing nuts under the burner assembly hand tight? Do not tighten with pliers. Figure 8 (c).

If you answered YES to a, b and c, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact Weber-Stephen Customer Service. Do not use barbecue.

Guide screw

Figure 6

Slide the cooking box to the left within the frame. Put washer on bolt. Insert the bolt through the frame and cooking box with the head of the bolt outside the frame. Figure 7. Add the keps nut. Tighten by holding the bolt with pliers while you tighten the nut with a wrench.

Figure 7

(b)

(a)

View from

(c) behind cooking box

Figure 8

Wing nuts

12

Image 12

Contents Natural Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents For Installation in Canada Gas supply testingGeneral Instructions StorageAssembly Check package contentsStep Page Check contents of hardware packs Assemble wheel frame Assemble top frameContinue frame assembly Install tubing plugsAdd front panel Add cooking box Install manifold bracket Install frame connectorInstall gas supply General Specifications for PipingTypical natural gas supply installation. Figure Gas line pipingTest connections Install igniter Check that all burner valves are offConnect flexible hose to manifold Check for gas leaks Install Flavorizer Bars and Cooking Grates Install the bottom trayInstall Lid Add tool holders, control panel and burner control knobsInstall swing table MWARNING The load limit for the swing table is 30 poundsComplete accessory installation Lighting To ExtinguishManual Lighting Periodic Cleaning CookingStorage and/or Nonuse PreheatingCast Iron Cooking Grates Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMWARNING Do not ignite burners while leak checking General Maintenance Main Burner Cleaning ProcedureMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Problem Check Cure Burners burn with a yellow or orange Flame, in conjunction with the smell of gasBurner does not light, or flame is low in High position Experiencing flare-ups11-12 53 46-48 Parts List Final Word Thanks