Weber 900 owner manual Install manifold bracket, Install frame connector, Install gas supply

Page 13

Step 8

Install manifold bracket

You will need: manifold bracket

Hook the bracket onto the manifold at the center burner valve. Figure 9. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace.

Frame brace

Manifold bracket

 

Figure 9

Step 9

Install frame connector

You will need: frame connector, two 1/4-20 x 1 3/4 inch bolts, two nylon washers and a 7/16 inch wrench.

Slip a washer on a bolt and insert through the hole in the cross brace and into the end of the frame connector. Insert the other bolt and washer into the other end through the cross brace and into the frame connector. Hold the frame connector square and tighten the bolts. Figure 10.

Figure 10

Step 10

Install gas supply

General Specifications for Piping

Note - Contact your local municipality for building codes regulating outdoor gas barbecue installations. In absence of Local Codes, you must conform to the latest edition of ANSI Z223.1. WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL.

Some of the following are general requirements taken from ANSI Z223.1, for gas supply installations. Refer to ANSI Z223.1 latest edition for complete specifications.

■This barbecue is designed to operate at 7 inches of water column pressure (.2526 psi).

■A manual shut-off valve must be installed outdoors, immediately ahead of the quick disconnect.

■An additional manual shut-off valve indoors should be

installed in the branch fuel line in an accessible location near the supply line.

■The quick disconnect connects to a 3/8 inch NPT

thread from the gas source. The quick disconnect fitting is a hand-operated device that automatically shuts OFF the flow of gas from the source when the barbecue is disconnected.

■The quick disconnect fitting can be installed

horizontally, or pointing downward. Installing the fitting with the open end pointing upward can result in collecting water and debris.

■The dust covers (supplied plastic plugs) help keep the

open ends of the quick disconnect fitting clean while disconnected.

mWARNING: Do not route the 12’ hose under a deck.

The hose must be visible.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Natural Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents Gas supply testing For Installation in CanadaGeneral Instructions StorageCheck package contents AssemblyStep Page Check contents of hardware packs Assemble top frame Assemble wheel frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install frame connector Install manifold bracketInstall gas supply General Specifications for PipingGas line piping Typical natural gas supply installation. FigureTest connections Check that all burner valves are off Install igniterConnect flexible hose to manifold Check for gas leaks Install the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMWARNING The load limit for the swing table is 30 pounds Install swing tableComplete accessory installation To Extinguish LightingManual Lighting Cooking Periodic CleaningStorage and/or Nonuse PreheatingCast Iron Cooking Grates Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking Main Burner Cleaning Procedure General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Flame, in conjunction with the smell of gas Problem Check Cure Burners burn with a yellow or orangeBurner does not light, or flame is low in High position Experiencing flare-ups11-12 53 46-48 Parts List Final Word Thanks
Top Page Image Contents