Weber 900 owner manual Install Lid, Add tool holders, control panel and burner control knobs

Page 18

Step 17

Install Lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 22.

Hair pin cotter

Hinge pin

Figure 22

Step 18

Add tool holders, control panel and burner control knobs

You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.

Hook the tool holders over the frame rail. Figure 23.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace.

Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 23 (a).

Push on the burner control knobs. Figure 23 (b).

Insert in

frame brace

(a)

Crossover

Ignition Button

Control panel

Phillips screws/

washers

(b)

Tool holders

Figure 23

18

Image 18

Contents Natural Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaGas supply testing StorageAssembly Check package contentsStep Page Check contents of hardware packs Assemble wheel frame Assemble top frameContinue frame assembly Install tubing plugsAdd front panel Add cooking box Install gas supply Install manifold bracketInstall frame connector General Specifications for PipingTypical natural gas supply installation. Figure Gas line pipingTest connections Install igniter Check that all burner valves are offConnect flexible hose to manifold Check for gas leaks Install Flavorizer Bars and Cooking Grates Install the bottom trayInstall Lid Add tool holders, control panel and burner control knobsInstall swing table MWARNING The load limit for the swing table is 30 poundsComplete accessory installation Lighting To ExtinguishManual Lighting Storage and/or Nonuse Periodic CleaningCooking PreheatingCast Iron Cooking Grates Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMWARNING Do not ignite burners while leak checking MCAUTION Do not enlarge the burner ports when cleaning General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High position Problem Check Cure Burners burn with a yellow or orangeFlame, in conjunction with the smell of gas Experiencing flare-ups11-12 53 46-48 Parts List Final Word Thanks