Weber 900 owner manual Install igniter, Check that all burner valves are off

Page 15

Step 11

Install igniter

Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.

The igniter lock nut is on the igniter.

Insert the top of the igniter up through the large part of the keyhole in the frame brace. Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Tighten the igniter lock nut. Figure 12.

Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

(a)

Frame brace

(b)

Figure 12

Keyhole in	Igniter lock nut
frame brace
(c)

Frame brace

Small part of keyhole in frame brace

Step 12

Check that all burner valves are off

You will need: one burner control knob.

Valves are shipped in the OFF position, but you should check to be sure. Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn they are off, proceed to the next step. Figure 13.

Figure 13

Step 13

Connect flexible hose to manifold

You will need: the 12 foot natural gas supply hose and a 3/4 inch wrench.

Thread fitting end of hose onto manifold. Figure 14 (a). Tighten with wrench.

(a)

Figure 14

15

Image 15

Contents Natural Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents Storage For Installation in CanadaGas supply testing General InstructionsAssembly Check package contentsStep Page Check contents of hardware packs Assemble top frame Assemble wheel frameContinue frame assembly Install tubing plugsAdd front panel Add cooking box General Specifications for Piping Install manifold bracketInstall frame connector Install gas supplyTypical natural gas supply installation. Figure Gas line pipingTest connections Install igniter Check that all burner valves are offConnect flexible hose to manifold Check for gas leaks Install the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMWARNING The load limit for the swing table is 30 pounds Install swing tableComplete accessory installation To Extinguish LightingManual Lighting Preheating Periodic CleaningCooking Storage and/or NonuseCast Iron Cooking Grates Annual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMWARNING Do not ignite burners while leak checking Weber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure MCAUTION Do not enlarge the burner ports when cleaningTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Experiencing flare-ups Problem Check Cure Burners burn with a yellow or orangeFlame, in conjunction with the smell of gas Burner does not light, or flame is low in High position11-12 53 46-48 Parts List Final Word Thanks