Step 10 | Step 11 |
Install igniter | Check that all burner valves are off |
Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.
The igniter lock nut is on the igniter.
Insert the top of the igniter up through the large part of the keyhole in the frame brace. Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Tighten the igniter lock nut. Figure 11.
Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.
You will need: one burner control knob.
(Valves are shipped in the OFF position, but you should check to be sure.) Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn they are off, proceed to the next step. Figure 12.
(a)
Figure 12
| Step 12 |
Frame brace | Connect flexible hose to manifold |
| You will need: the 12 foot natural gas supply hose and a |
(b) | 3/4 inch wrench. |
| Thread fitting end of hose onto manifold. Figure 13 (a). |
| Tighten with wrench. |
| (a) |
Figure 11
Keyhole in | Igniter lock nut |
frame brace | |
| (c) |
Frame brace
Small part of
keyhole inFigure 13 frame brace
14