Weber 3000 Series owner manual Install Flavorizer Bars and Cooking Grates

Page 17

Check:

a)Hose to manifold connection. Figure 18 (a).

b)Manifold to side burner hose connection.Figure 18 (b).

mWARNING: If there is a leak at connection (a), retighten the fitting with a wrench and recheck for leaks with soap and water solution.

If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact

Weber-Stephen Customer Service.

c)Side burner hose to side burner connection. Figure 18 (c).

d)Valves to manifold connections. Figure 18 (d).

e)Hose to quick disconnect connection. Figure 18 (e).

mWARNING: If there is a leak at connections

(b), (c), (d) or (e), turn OFF the gas. DO NOT OPERATE

THE BARBECUE. Contact Weber-Stephen Customer Service.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

(a)(b)

(c)

Step 16

Install Flavorizer Bars and Cooking Grates

You will need: five long Flavorizer Bars, eight short Flavorizer Bars and two cooking grates.

Set the long Flavorizer Bars side to side in the lower position, then set the short Flavorizer Bars front to back in the upper position in the cooking box. Figure 19.

Figure 19

The open "U" of the cooking grates goes down. Set the cooking grates onto the ledges in the cooking box. Figure 20.

Figure 20

(d)

Figure 18

(e)

17

Image 17
Contents Genesis 3000 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Gas supply testing For Installation in CanadaGeneral Instructions StorageStep AssemblyCheck package contents BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsInsert casters Continue frame assemblyComplete frame assembly Add cooking box Install side burner locksGeneral Specifications for Piping Install gas supplyGas line piping Test connectionsConnect flexible hose to manifold Install igniter Check that all burner valves are offMWARNING Make sure gas supply is OFF Install side burnerInstall manifold bracket MWARNING Do not ignite burners while leak checking Check for gas leaksDeath and damage to property Install Flavorizer Bars and Cooking Grates Install the lid Install the bottom trayMCAUTION Make sure both locks have snapped into place Secure side burnerInstall swing table Complete accessory installation Turn gas supply OFF at the source, then push down LightingTo Extinguish Manual Lighting Lighting only the side burner. Figure Lighting the side burnerCooking Periodic CleaningStorage and/or Nonuse Drippings and greaseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations Burner flame pattern is erratic. Flame is low Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting14-15 17-18,15 21-22 26 27 Use only Weber factory authorized parts. Parts ListPage Page Final Word Thanks