Weber 3000 Series owner manual Check contents of hardware packs

Page 9

Catch pan holder

Manifold bracket

Side burner assembly

Burner grate

Side burner knob

Two side burner lock

Note: The locks are taped to the inside of the side burner lid.

Check contents of hardware packs

Three burner control knobs

Three tool holders

Five tubing plugs (two are spares)

Two wheel hubcaps (actual size)

Two hinge pins

(hardware size: 1/4 x 1 1/2 inch clevis pin) (actual size)

Five 1/4-20 x 2 inch bolts (actual size)

Six 1/4-20 x 1/2 inch bolts (actual size)

Two 10-24 x 1 3/4 machine screws (actual size)

Two 10-24 hex nuts (actual size)

Fifteen 1/4 inch nylon washers (actual size)

1/4-20 keps nut

Two hair pin cotters

Swing table end bracket

Two Phillips screws/washers

9

Image 9
Contents Genesis 3000 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Gas supply testing For Installation in CanadaGeneral Instructions StorageAssembly Check package contentsStep BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsContinue frame assembly Complete frame assemblyInsert casters Add cooking box Install side burner locksGeneral Specifications for Piping Install gas supplyGas line piping Test connectionsConnect flexible hose to manifold Install igniter Check that all burner valves are offInstall side burner Install manifold bracketMWARNING Make sure gas supply is OFF Check for gas leaks Death and damage to propertyMWARNING Do not ignite burners while leak checking Install Flavorizer Bars and Cooking Grates Install the lid Install the bottom trayMCAUTION Make sure both locks have snapped into place Secure side burnerInstall swing table Complete accessory installation Lighting To ExtinguishTurn gas supply OFF at the source, then push down Manual Lighting Lighting only the side burner. Figure Lighting the side burnerCooking Periodic CleaningStorage and/or Nonuse Drippings and greaseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider Stopper Guards Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations Burner flame pattern is erratic. Flame is low Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting14-15 17-18,15 21-22 26 27 Use only Weber factory authorized parts. Parts ListPage Page Final Word Thanks