Weber 3000 Series owner manual Burner does not light, or flame is low in High position

Page 30

TROUBLESHOOTING

Problem

Check

Cure

 

 

 

Burners burn with a yellow or orange flame, in conjunction with the smell of gas.

Inspect Weber Spider Stopper

Clean Weber Spider Stopper

Guards for possible obstructions.

Guards. (See Section "Annual

(Blockage of holes.)

Maintenance".)

Burner does not light, or flame is low in HIGH position.

Is fuel hose bent or kinked?

Straighten fuel hose.

 

 

Does the Front burner light with a

If you can light the Front burner

match?

with a match, then check the

 

Crossover Ignition System.

Experiencing flare-ups:

mCAUTION: Do not line the bottom tray with aluminum foil.

Are you preheating barbecue in the

All burners on high for 10 to 15

prescribed manner?

minutes for preheating.

 

 

Are the cooking grates and

Clean thoroughly. (See Section

Flavorizer Bars heavily coated with

"Periodic Cleaning".)

burned-on grease?

 

 

 

Is the bottom tray "dirty" and not

Clean bottom tray.

allowing grease to flow into catch

 

pan?

 

Are burners clean?

Clean burners. (See Section

Burner flame pattern is erratic. Flame is low

"General Maintenance".)

when burner is on HIGH. Flames do not run

 

the whole length of the burner tube.

 

Inside of lid appears to be “peeling.” (Resembles paint peeling.)

The lid is porcelain-on-steel, not

Clean thoroughly. (See Section

paint. It cannot “peel.” What you are

"Periodic Cleaning".)

seeing is baked on grease that has

 

turned to carbon and is flaking off.

 

THIS IS NOT A DEFECT.

 

If the problem cannot be corrected using these methods, please contact Weber-Stephen Customer Service.

30

Image 30
Contents Genesis 3000 Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents General Instructions For Installation in CanadaGas supply testing StorageAssembly Check package contentsStep BER E W REB Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyInsert casters Install side burner locks Add cooking boxGas line piping Install gas supplyGeneral Specifications for Piping Test connectionsInstall igniter Check that all burner valves are off Connect flexible hose to manifoldInstall side burner Install manifold bracketMWARNING Make sure gas supply is OFF Check for gas leaks Death and damage to propertyMWARNING Do not ignite burners while leak checking Install Flavorizer Bars and Cooking Grates Install the bottom tray Install the lidSecure side burner MCAUTION Make sure both locks have snapped into placeInstall swing table Complete accessory installation Lighting To ExtinguishTurn gas supply OFF at the source, then push down Manual Lighting Lighting the side burner Lighting only the side burner. FigureStorage and/or Nonuse Periodic CleaningCooking Drippings and greaseAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure Main Burner Flame PatternView from behind cooking box Wing nuts Crossover Ignition System Operations Burner does not light, or flame is low in High position Burner flame pattern is erratic. Flame is lowSide Burner Troubleshooting Side Burner Maintenance14-15 17-18,15 21-22 26 27 Parts List Use only Weber factory authorized parts.Page Page Final Word Thanks