Weber 3000 Series owner manual Side Burner Troubleshooting, Side Burner Maintenance

Page 31

Side Burner Troubleshooting

mWARNING: Before attempting any troubleshooting steps, all gas controls and supply valves should be in the OFF position.

Problem	Check	Cure

Side burner does not light.	Is gas supply off?	Turn supply on.

Flame is low in HIGH position.	Is fuel hose bent or kinked?	Straighten hose.

Flame is very yellow in conjunction with the smell of gas,

OR

Burner makes popping noise in conjunction with the smell of gas.

Inspect the Weber Spider Stopper	Clean Weber Spider Stopper
Guard for possible obstructions.	Guard. (See Section "Annual
(Blockage of holes.)	Maintenance.")

Push button ignition does not work.

Does burner light with a match?

If match lights burner, check igniter (see below).

Side Burner Maintenance

mWARNING: All gas controls and supply valves should be in the OFF position.

Check igniter: Remove side burner cover. To remove side burner cover, remove control knob and screws that hold cover to bottom. Figure 18. Make sure wire is connected between igniter and electrode. Check that igniter lock nut is tight. Figure 19.

Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

Venturi/Burner

Igniter wire	Electrode

Igniter

Adjust igniter electrode. Gap should be 1/8 to 3/16 inch

from tip of electrode to burner. Figure 20. Spark should beFigure 19 a white/blue color, not yellow.

1/8 to 3/16 inch gap

Figure 18

Figure 20

31

Image 31

Contents Genesis 3000 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Storage For Installation in CanadaGas supply testing General InstructionsCheck package contents AssemblyStep BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Add cooking box Install side burner locksTest connections Install gas supplyGeneral Specifications for Piping Gas line pipingConnect flexible hose to manifold Install igniter Check that all burner valves are offInstall manifold bracket Install side burnerMWARNING Make sure gas supply is OFF Death and damage to property Check for gas leaksMWARNING Do not ignite burners while leak checking Install Flavorizer Bars and Cooking Grates Install the lid Install the bottom trayMCAUTION Make sure both locks have snapped into place Secure side burnerInstall swing table Complete accessory installation To Extinguish LightingTurn gas supply OFF at the source, then push down Manual Lighting Lighting only the side burner. Figure Lighting the side burnerDrippings and grease Periodic CleaningCooking Storage and/or NonuseInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsView from behind cooking box Wing nuts Crossover Ignition System Operations Burner flame pattern is erratic. Flame is low Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner Troubleshooting14-15 17-18,15 21-22 26 27 Use only Weber factory authorized parts. Parts ListPage Page Final Word Thanks