PRE-START Check List, Lighting Instructions

PRE-START CHECK LIST:

DANGER

Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps should be performed after the grill has been assembled and prior to each use. DO NOT operate this grill until you have read and understand ALL of the warnings and instructions in this manual.

•Ensure that the grill is properly assembled.

•Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the grill being used. Replace with hose and regulator Model No. 155-4580-S, which can be obtained by contacting customer service at 800-527-0717.

•Leak check all gas connections, hose and propane tank. See section on “Leak Testing”.

•Ensure that all electrical supply cords are properly grounded. Keep any electrical supply cord and the fuel supply hose away from any heated surfaces. Hose should be at least 3 inches from hot surfaces.

•Position your grill on a non-combustible level surface in a well ventilated location, a safe distance 10 ft. (3.1 m) from combustible materials, buildings and overhangs.

•Properly place the empty grease cup under the grease drain hole in the bottom of the grill to catch grease during use.

•DO NOT block ventilation areas in sides, back or cart compartment of grill.

LIGHTING INSTRUCTIONS:

WARNING

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the cylinder valve are turned to the “OFF” position.

3.Turn on the fuel supply by slowly rotating the cylinder valve knob counter-clockwise to full open.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1.Open lid before lighting burner.

2.Make sure all control knobs are in the “OFF” position.

3.Select the burner to be lit. Push and turn the control knob of that burner to the “HIGH” position

LIGHTS LUCES

Read Instructions Before Lighting:

1.Open lid during lighting.

2.Select a burner to be lit. Push and turn control knob of that burner to “HIGH.” Press electronic igniter and hold for 3-5 seconds.

3.If ignition does not occur in 5 seconds, turn control knob to “OFF,” wait 5 minutes and repeat lighting procedure.

Lea las Instrucciones Antes de Iluminación:

1.Abra la tapa durante el encendimiento.

2.Seleccione la hornilla que va a encender. Empuje y gire la perilla de control de esa hornilla a la posición “ALTO”. Oprima el encendedor electrónico

y manténgalo oprimido 3 a 5 segundos.

3.Si la hornilla NO se enciende en 5 segundos, gire la perilla de control a la posición "APAGADO"espere 5 minutos y repita el procedimiento de encendido.

NG Conversion

Kit Required

Kit de la Conversión

del NG Requerido