6.Repeat steps
7.To turn off, turn each control knob clockwise until it locks in the “OFF” position. This does not turn off the gas flow from the cylinder..
Note: If burner does not light or flame is too low, See “Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
Lighting Hole
2.Make sure all control knobs are in the “OFF” position.
3.Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the left hand side of the grill to approximately 1/2” (1 to 2 cm) from the burner.
4.Turn on the FAR LEFT burner control knob to the “HIGH” position. The burner should light within 5 seconds.
5.If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to dissipate and repeat lighting procedure.
6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the “HIGH” position.
Matchlighter |
7.If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected.
Note: If burner does not light or flame is too low, See “Trouble Shooting” section of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color between
See section in manual on burner adjustment to adjust flame.
LIGHTING THE SEAR BURNER:
1.Open lid before lighting sear burner.
2.Make sure control knob is in the “OFF” position.
3.Push and turn the control knob to the “HIGH” position. Continue to push in control knob while pressing electronic igniter for
4.Once burner is lit, continue to push and hold control knob for 30 seconds.
5.If ignition does NOT occur in 5 seconds, turn control knob to “OFF”, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.
6.To turn off, turn control knob clockwise until it locks in “OFF” position. Note: If burner does not light or flame is too low, See “Trouble
Shooting” section of the owners manual.
SEAR BURNER
HORNILLA PARA
DORAR
MAXIMUM SEAR
BURNER WEIGHT = 15 lbs.
PESO MÁXIMO DE LA HORNILLA PARA DORAR = 6.8 kg
Sear Burner Lighting Instructions:
Instrucciones de Iluminación para la Hornilla para Dorar:
MATCH LIGHTING THE SEAR BURNER:
1.Open the lid to the sear burner before lighting.
2.Turn the burner control knob to “OFF”.
3.Strike and carefully place a match approximately 1/2” (1 to 2 cm) from the burner.
4.Push and turn the sear burner control knob to the “HIGH” position. Continue to push in control knob while holding a match to burner. The burner should light within 5 seconds.
5.Once burner is lit, continue to push and hold control knob for 30 seconds.
6.If the burner does not light, turn the control knob to “OFF” and wait 5 minutes for gas to dissipate and repeat lighting procedure.
7.If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the sear burner until the problem is found and corrected.
Note: If burner does not light or flame is too low, See “Trouble Shooting” section of the owners manual.
10