Suburban Mfg 12155-00-FNHJAA, 12155-00-FNFNAA manual Nebulizer Oxygen Supply Hose, Cotter Pin

Chapter 4 - Repairs and Replacements

Extension

Cotter Pin

Opening

for

Nebulizer

Extension

Figure 19. Nebulizer Extension and	Figure 20. Nebulizer in Place
Cotter Pin
5.	Attach the free end of the nebulizer plastic tubing to a
	50 psi wall oxygen outlet or an oxygen cylinder.
	Note: Your oxygen supplier is the best source to make
	these connections for you.

Nebulizer Assembly, Partial

P/N 749510

The partial nebulizer assembly includes the bottle, cap, and regulator (Figure 18). This partial assembly does NOT include the extension, cotter pin, oxygen supply hose, or hose barb fitting. To fit the non-included parts to this assembly, refer to Table 2 on Page 17 for appropriate page references. Note: When ordering a new partial nebulizer assembly, also order a new extension, P/N 754061. The cotter pin, supply hose, and barb fitting can be transferred from your old nebulizer, however, the extension is bonded in place and difficult to remove.

Nebulizer Oxygen Supply Hose

P/N 750492

This 1/4 in. ID, 3/8 in. OD, 48 in. long tubing (Figure 18) connects the nebulizer to your oxygen source. The source can be a built-in system or an oxygen tank.

1.Push one end of the oxygen supply hose onto the barb fitting on top the bottle (Figure 21). Note:Asmall amount of grease on the barbs will ease assembly.

2.Attach the free end of the hose to a 50 psi wall oxygen outlet or an oxygen cylinder. Note:Your oxygen supplier is the best source to make these connections for you.

20 SSCI - Suburban Surgical Company, Inc.