A&D TM-2655P manual Installing the Printer Paper, Paper installation procedure

Page 21

6. INSTALLING THE PRINTER PAPER

(This chapter is applicable only to the TM-2655P.)

With the power turned on, install the printer paper as follows:

1. Cut the top end of the printer paper with scissors. If the end is not smooth, it may cause a paper jam or damage the printer head.

2. Press lightly on the center of the printer cover to open the cover.

3. Raise the lever located on the right side of the printer. Insert the printer paper into the paper feed slot as shown. The paper is fed automatically.

4. Press the PAPER FEED switch to feed the paper by 10 cm. Confirm that the paper is fed straight. If not, re-install the paper because it may cause a paper jam.

5. Lower the lever and feed the paper. The paper will be cut automatically.

6. Close the cover. Press lightly on the center of the printer cover to secure it in position.

Note

z With high-speed printing, about 700 printings can be performed. With three-line printing, about 600 printings.

z Replace the printer paper when the red end is reached.

Fig.11 Paper installation procedure

zUse the specified thermal paper, which is sold separately.

13

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Automatic Blood Pressure Monitor Page Important information that helps users operate the device Compliance with the Australian EMC Frame Work ComplianceGrounding Safety PrecautionsWhen installing and storing the device General PrecautionsMust be disposed of according to the applicable regulations Page Contents Troubleshooting External Dimensions Introduction FeaturesItems contained Unpacking and InspectionPerformance specifications SpecificationsMain Unit Part NamesRear Panel SymbolsProper installation InstallationBe sure to insert your arm to the shoulder OperationMeasurement results Setting the Clock Clock Adjustment ModeSetting Example Page Paper installation procedure Installing the Printer PaperFunction Setting Mode Setting the FunctionsF02 Off Description of the FunctionsLine printing Table printing Bit pattern printing Printing SamplesChannel 1 Miniature DIN 8-pin Communication SpecificationsChannel 2 D-sub 9-pin Cable connection diagramReplacing the Arm Cuff Cover MaintenanceError Codes Replacing the FusesChecking the Counter Cleaning MaintenanceOptions and Consumables Troubleshooting External dimensions External Dimensions
Top Page Image Contents