A&D TM-2655P manual General Precautions, When installing and storing the device

Page 6

GENERAL PRECAUTIONS

Obey the following precautions for safe and correct usage.

Precautions unique to the TM-2655/TM-2655P appear on the relevant page in this manual. Read the manual thoroughly before use.

When installing and storing the device

„Install or store the device away from moisture.

„Do not install or store the device where the device may be badly affected by extreme temperature, humidity, direct sunlight, draft, dust, salinity or sulfur content in the air.

„Do not install or store the device where chemicals, and corrosive or explosive gases are stored or present.

„Install or store the device in a secure, level and stable location.

„Install or store the device where adequate power is provided. (Where a medical 3P electrical outlet is provided.)

Before use

„Check to make sure the device operates safely and accurately.

„Check all cables for proper connection.

„When other medical equipment is used at the same time, a diagnostic error or dangerous situation may occur. Check all connections to make sure they do not interfere with each other.

„When other telemeters are used, check that mutual interference will not cause a problem.

During use

„Check the patient and the device during use.

„If medical or operational problems are found in the device or the patient, stop using the device immediately, check the status of the patient and take proper action.

„Do not use the device during MRI scanning.

„Do not use the device on a patient using a heart-lung machine.

„High frequency interference by electrosurgery or energy discharged by a defibrillator may damage the device. Follow the precautions described in the manual for each device.

„Do not use a cellular telephone near the device. It could affect the device’s operation.

„The personal computer and medical equipment connected to the device are not allowed to be in the patient area.

„The personal computer used must conform to IEC60950

After use

„Follow the predetermined procedure to return the operation switches to their original positions, and then turn off the power.

„Do not forcibly pull out the cables. Hold the connector with your hand when disconnecting the cable.

„Keep the device clean and in proper operating condition so that it can be used without problem during the next operation.

„Clean the accessories and arrange them before storage.

Environmental protection

„Remove the built-in lithium battery from the device when the device is to be disposed of.

„This device, any part of, and the built-in lithium battery are not treated as ordinary household waste,

iv

Image 6
Contents Automatic Blood Pressure Monitor Page Important information that helps users operate the device Compliance Compliance with the Australian EMC Frame WorkSafety Precautions GroundingGeneral Precautions When installing and storing the deviceMust be disposed of according to the applicable regulations Page Contents Troubleshooting External Dimensions Features IntroductionUnpacking and Inspection Items containedSpecifications Performance specificationsPart Names Main UnitSymbols Rear PanelInstallation Proper installationOperation Be sure to insert your arm to the shoulderMeasurement results Setting the Clock Clock Adjustment ModeSetting Example Page Installing the Printer Paper Paper installation procedureSetting the Functions Function Setting ModeDescription of the Functions F02 OffPrinting Samples Line printing Table printing Bit pattern printingCommunication Specifications Channel 1 Miniature DIN 8-pinCable connection diagram Channel 2 D-sub 9-pinMaintenance Replacing the Arm Cuff CoverError Codes Replacing the FusesChecking the Counter Maintenance CleaningOptions and Consumables Troubleshooting External Dimensions External dimensions