A&D TM-2655P manual Maintenance, Cleaning

Page 29

9-5 Maintenance

Do not open the device. It uses delicate electronic components and an intricate air unit that could be damaged. If you can not fix the problem using the troubleshooting instructions, request service from your supplier or from the A&D service group. The A&D service group will provide technical information, spare parts and units to authorized suppliers.

The technical testing procedures, which should be done at least every two years, can be performed either by the manufacturer or by an authorized repair service in accordance with the regulations governing manufacturing of medical products.

9-6 Cleaning

CAUTION

zNever immerse the TM-2655/TM-2655P in water for cleaning, that may damage the electronic parts inside.

zNever use thinner or a strong detergent for cleaning, that may discolor or deform the plastic case and display panel.

Housing case

Clean the case gently using a soft cloth moistened with water and mild detergent or alcohol.

Display panel

Clean the display gently so as not to scratch the panel surface. Use a soft cloth moistened with water.

Arm cuff cover

When the arm cuff cover becomes dirty or it is worn out, replace with a new one. Refer to “9-1 Replacing the Arm Cuff Cover”.

Note

If the cover is not installed properly, it may cause problems in operation.

21

Image 29
Contents Automatic Blood Pressure Monitor Page Important information that helps users operate the device Compliance with the Australian EMC Frame Work ComplianceGrounding Safety PrecautionsWhen installing and storing the device General PrecautionsMust be disposed of according to the applicable regulations Page Contents Troubleshooting External Dimensions Introduction FeaturesItems contained Unpacking and InspectionPerformance specifications SpecificationsMain Unit Part NamesRear Panel SymbolsProper installation InstallationBe sure to insert your arm to the shoulder OperationMeasurement results Setting Example Setting the ClockClock Adjustment Mode Page Paper installation procedure Installing the Printer PaperFunction Setting Mode Setting the FunctionsF02 Off Description of the FunctionsLine printing Table printing Bit pattern printing Printing SamplesChannel 1 Miniature DIN 8-pin Communication SpecificationsChannel 2 D-sub 9-pin Cable connection diagramReplacing the Arm Cuff Cover MaintenanceChecking the Counter Error CodesReplacing the Fuses Cleaning MaintenanceOptions and Consumables Troubleshooting External dimensions External Dimensions