A&D 2 Plus owner manual Transmitter

Page 13

THE TRANSMITTER

The compact transmitter module screws into a standard

7/16" HP port. The transmitter automatically activates when it senses pressure from the cylinder. Once activated, it sends pressure information via a low frequency radio wave to the wrist unit.

One of the unique features of the transmitter is that it sends along a special code each time it transmits pressure information. The computer "listens" to the code, and, if it is the correct code, accepts the pressure information. This feature allows more than one Monitor 3 Air system to be used without information becoming mixed up, i.e. you reading your dive buddy's air information.

6

The Transmitter

Image 13

Contents Page Copyright Notice Safety Considerations Guidelines for Using the Monitor 3 Air Page Table of Contents Memory Mode Page Introduction What is a Dive ComputerIntroduction Computer Screen Features of the Monitor 3 AirMonitor 3 Air display zones and contact letter designations Transmitter This section Step Attaching the Transmitter to Your RegulatorPairing the Wrist Unit to the Transmitter Preparation Preparation Checking the Battery Power Using the Monitor 3 Air Without the TransmitterThis section Preparation for the Dive Diving with the Monitor 3 Air Current Depth Functions During the DiveMaximum Depth Dive TimeAscent Rate Display Ascent RateNo-Stop Time No-stop time at Minutes remaining Antenna SymbolDigital Air Time Remaining ATR Graphic Air Time Remaining ATRHigh Air Consumption Warning Decompression Stop Information Total Ascent Time SOS ModeFunctions at the Surface Surface Mode Surface mode iconUpon surfacing Wait-to-fly Recommendations Wait-to-fly TimeSurface Interval Time Desaturation TimeMicrobubble Warning Altitude sectors Diving at AltitudeExceeding the Altitude Limit Altitude dive Summary of Attention Messages and AlarmsLost transmission after 40 seconds Alarms Low computer battery Activating Memory Mode Scrolling through logged dives Downloading the Memory to a PC OverviewMemory Mode Activation From Ready Mode or Surface Mode, touchScrolling through Logged Dives Exiting Memory ModeMemory Mode This section Activation from Ready-Mode Ready ModeMaximum allowable no-stop time at that depth Surface Mode Activation from Surface ModeIncrease Time Decrease Time Planning a Decompression Dive Step Pre-Dive Planning Mode Page Care During the Dive Care Before the DiveCare & Maintenance Replacing the Battery Operating TemperaturePage Operational Performance No-Decompression Model Technical SpecificationsZH-L8 ADT Calculation Model Workload and TemperatureSummary