A&D 2 Plus owner manual Maximum allowable no-stop time at that depth

Page 50

STEP 2

Touch contacts A & D to confirm the selection. The word RUN will flash for about five seconds and then start scrolling through the available time-depth combinations.

Section 4: Pre-Dive Planning Mode

STEP 3 The Monitor scrolls from 50 to 200 feet in 10-foot increments. For each depth the computer gives

the maximum allowable no-stop time at that depth.

Note: If you want to stay longer than the no-stop time limit, proceed to "Planning a Decompres- sion Dive" on page 46.

43

Image 50

Contents Page Copyright Notice Safety Considerations Guidelines for Using the Monitor 3 Air Page Table of Contents Memory Mode Page What is a Dive Computer IntroductionIntroduction Features of the Monitor 3 Air Computer ScreenMonitor 3 Air display zones and contact letter designations Transmitter This section Attaching the Transmitter to Your Regulator StepPairing the Wrist Unit to the Transmitter Preparation Preparation Using the Monitor 3 Air Without the Transmitter Checking the Battery PowerThis section Preparation for the Dive Diving with the Monitor 3 Air Functions During the Dive Current DepthDive Time Maximum DepthAscent Rate Ascent Rate DisplayNo-Stop Time Antenna Symbol No-stop time at Minutes remainingGraphic Air Time Remaining ATR Digital Air Time Remaining ATRHigh Air Consumption Warning Decompression Stop Information SOS Mode Total Ascent TimeUpon surfacing Surface Mode Surface mode iconFunctions at the Surface Wait-to-fly Time Wait-to-fly RecommendationsDesaturation Time Surface Interval TimeMicrobubble Warning Diving at Altitude Altitude sectorsExceeding the Altitude Limit Summary of Attention Messages and Alarms Altitude diveLost transmission after 40 seconds Alarms Low computer battery Activating Memory Mode Scrolling through logged dives Overview Downloading the Memory to a PCMemory Mode From Ready Mode or Surface Mode, touch ActivationExiting Memory Mode Scrolling through Logged DivesMemory Mode This section Ready Mode Activation from Ready-ModeMaximum allowable no-stop time at that depth Activation from Surface Mode Surface ModeIncrease Time Decrease Time Planning a Decompression Dive Step Pre-Dive Planning Mode Page Care Before the Dive Care During the DiveCare & Maintenance Operating Temperature Replacing the BatteryPage Technical Specifications Operational Performance No-Decompression ModelWorkload and Temperature ZH-L8 ADT Calculation ModelSummary