A&D 2 Plus owner manual Safety Considerations

Page 3

Pay special attention to warnings and cautions, which are denoted by this symbol:

WARNINGS alert you to any procedure or situation that may result in serious injury or death.

CAUTIONS alert you to any situation or technique that will result in damage to the product.

Safety Considerations

You must carefully read this entire manual before using your Monitor 3 Air.

WARNING: Diving has many inherent risks. Decom- pression sickness is among the most serious of those risks. Even if you follow the instructions in this manual carefully, it is possible that you may be seriously injured or die from decompression sickness, or some other inherent risk of SCUBA diving. Unless you are fully aware of these risks and are willing to personally accept and assume responsibility for those risks, do not use the Monitor 3 Air!

The Monitor 3 Air is a sophisticated decompression tool to assist a trained and certified SCUBA diver in making decisions concerning dive planning and execution. As with any tool, the Monitor 3 Air may be misused if the following safety and operational precautions are not strictly followed. If they are followed, careful use of the Monitor 3 Air can increase your diving enjoyment and reduce the risk of decompression sickness (DCS); if they are not followed, you will be placing yourself at serious risk for DCS.

Image 3 A&D 2 Plus owner manual Safety Considerations
Contents Page Copyright Notice Safety Considerations Guidelines for Using the Monitor 3 Air Page Table of Contents Memory Mode Page Introduction What is a Dive ComputerIntroduction Computer Screen Features of the Monitor 3 AirMonitor 3 Air display zones and contact letter designations Transmitter This section Step Attaching the Transmitter to Your RegulatorPairing the Wrist Unit to the Transmitter Preparation Preparation Checking the Battery Power Using the Monitor 3 Air Without the TransmitterThis section Preparation for the Dive Diving with the Monitor 3 Air Current Depth Functions During the DiveMaximum Depth Dive TimeAscent Rate Display Ascent RateNo-Stop Time No-stop time at Minutes remaining Antenna SymbolDigital Air Time Remaining ATR Graphic Air Time Remaining ATRHigh Air Consumption Warning Decompression Stop Information Total Ascent Time SOS ModeSurface Mode Surface mode icon Functions at the SurfaceUpon surfacing Wait-to-fly Recommendations Wait-to-fly TimeSurface Interval Time Desaturation TimeMicrobubble Warning Altitude sectors Diving at AltitudeExceeding the Altitude Limit Altitude dive Summary of Attention Messages and AlarmsLost transmission after 40 seconds Alarms Low computer battery Activating Memory Mode Scrolling through logged dives Downloading the Memory to a PC OverviewMemory Mode Activation From Ready Mode or Surface Mode, touchScrolling through Logged Dives Exiting Memory ModeMemory Mode This section Activation from Ready-Mode Ready ModeMaximum allowable no-stop time at that depth Surface Mode Activation from Surface ModeIncrease Time Decrease Time Planning a Decompression Dive Step Pre-Dive Planning Mode Page Care During the Dive Care Before the DiveCare & Maintenance Replacing the Battery Operating TemperaturePage Operational Performance No-Decompression Model Technical SpecificationsZH-L8 ADT Calculation Model Workload and TemperatureSummary