A&D 2 Plus owner manual Features of the Monitor 3 Air, Computer Screen

Page 11

Features of the Monitor 3 Air

The Monitor 3 Air is made up of two compact units: the computer/display unit which is usually worn on the wrist, and the high pressure (HP) transmitter which is screwed into the regulator first-stage HP port.

THE COMPUTER SCREEN

The Monitor 3 Air has a large liquid crystal display (LCD) and features large numbers and graphics. The screen is luminous for easy reading during low light dives, including night dives and cave dives.

The screen is organized into four zones (see figure on opposite page): The MODE zone, DEPTH zone, TIME zone and AIR zone. The Mode Zone has five icons which indicate altitude, low battery, Pre-dive Planning Mode, Memory Mode, and Surface Mode.

Next to the Mode Zone is the Depth Zone. This grouping of numbers includes the current depth, maximum depth decompression stop depth, and ascent rate information.

Beside the Depth Zone is the Time Zone. The Time Zone shows total dive time, total ascent time, no stop time, and, while in decompression, decompression stop time.

To the far right of the screen is the Air Zone. The Air Zone shows current cylinder pressure, a graphical representation

4

of air time remaining and a digital readout of remaining air time. In addition, their are two warning icons: one for interrupted transmission and the other for high breathing rate.

THE ELECTRICAL CONTACTS

All surface operations and mode changes are made by the use of four electrical contacts placed around the Monitor 3 Air's screen. These contacts are identified as A, B, C and D (see figure on opposite page). As a rule, contact A is always touched in conjunction with one of the other three con- tacts. After entering different modes, such as Memory Mode or Pre-Dive Planning Mode, contact B always decreases a value, and contact C always increases a value (always in combination with A). To make contact, simply moisten your fingertips and touch the appropriate pair of contacts at the same time. Release the contact as soon as the operation has been activated, usually no more than one second.

Image 11 A&D 2 Plus owner manual Features of the Monitor 3 Air, Computer Screen
Contents Page Copyright Notice Safety Considerations Guidelines for Using the Monitor 3 Air Page Table of Contents Memory Mode Page Introduction What is a Dive ComputerIntroduction Computer Screen Features of the Monitor 3 AirMonitor 3 Air display zones and contact letter designations Transmitter This section Step Attaching the Transmitter to Your RegulatorPairing the Wrist Unit to the Transmitter Preparation Preparation Checking the Battery Power Using the Monitor 3 Air Without the TransmitterThis section Preparation for the Dive Diving with the Monitor 3 Air Current Depth Functions During the DiveMaximum Depth Dive TimeAscent Rate Display Ascent RateNo-Stop Time No-stop time at Minutes remaining Antenna SymbolDigital Air Time Remaining ATR Graphic Air Time Remaining ATRHigh Air Consumption Warning Decompression Stop Information Total Ascent Time SOS ModeUpon surfacing Surface Mode Surface mode iconFunctions at the Surface Wait-to-fly Recommendations Wait-to-fly TimeSurface Interval Time Desaturation TimeMicrobubble Warning Altitude sectors Diving at AltitudeExceeding the Altitude Limit Altitude dive Summary of Attention Messages and AlarmsLost transmission after 40 seconds Alarms Low computer battery Activating Memory Mode Scrolling through logged dives Downloading the Memory to a PC OverviewMemory Mode Activation From Ready Mode or Surface Mode, touchScrolling through Logged Dives Exiting Memory ModeMemory Mode This section Activation from Ready-Mode Ready ModeMaximum allowable no-stop time at that depth Surface Mode Activation from Surface ModeIncrease Time Decrease Time Planning a Decompression Dive Step Pre-Dive Planning Mode Page Care During the Dive Care Before the DiveCare & Maintenance Replacing the Battery Operating TemperaturePage Operational Performance No-Decompression Model Technical SpecificationsZH-L8 ADT Calculation Model Workload and TemperatureSummary