A&D 2 Plus owner manual Microbubble Warning

Page 35

Section 2: Diving with the Monitor 3 Air

Microbubble Warning

Repetitive diving may cause microbubbles to accumulate in the lungs if the surface interval between dives is not long enough. Ignoring decompression stops or an excessive ascent rate can also lead to bubble formation. In order to reduce the risk of decompression sickness for future repetitive dives, the surface interval should be planned long enough to reduce the risk of decompression sickness. If the Monitor 3 Air calculates that the forma- tion of microbubbles may occur during the surface interval, it will advise the diver to extend the surface interval. The display “Atn” (= attention) is visible in the depth display area during the surface mode. While “Atn” is displayed, the diver should not undertake another dive.

Note: If a dive has to be made while “Atn” is displayed, the amount of “Atn”-time for the following dive can increase considerably. During the dive, no-stop times will be much shorter and decompression times will increase.

Microbubble formation warning

Atn = Attention

28

Image 35 A&D 2 Plus owner manual Microbubble Warning
Contents Page Copyright Notice Safety Considerations Guidelines for Using the Monitor 3 Air Page Table of Contents Memory Mode Page Introduction What is a Dive ComputerIntroduction Computer Screen Features of the Monitor 3 AirMonitor 3 Air display zones and contact letter designations Transmitter This section Step Attaching the Transmitter to Your RegulatorPairing the Wrist Unit to the Transmitter Preparation Preparation Checking the Battery Power Using the Monitor 3 Air Without the TransmitterThis section Preparation for the Dive Diving with the Monitor 3 Air Current Depth Functions During the DiveMaximum Depth Dive TimeAscent Rate Display Ascent RateNo-Stop Time No-stop time at Minutes remaining Antenna SymbolDigital Air Time Remaining ATR Graphic Air Time Remaining ATRHigh Air Consumption Warning Decompression Stop Information Total Ascent Time SOS ModeUpon surfacing Surface Mode Surface mode iconFunctions at the Surface Wait-to-fly Recommendations Wait-to-fly TimeSurface Interval Time Desaturation TimeMicrobubble Warning Altitude sectors Diving at AltitudeExceeding the Altitude Limit Altitude dive Summary of Attention Messages and AlarmsLost transmission after 40 seconds Alarms Low computer battery Activating Memory Mode Scrolling through logged dives Downloading the Memory to a PC OverviewMemory Mode Activation From Ready Mode or Surface Mode, touchScrolling through Logged Dives Exiting Memory ModeMemory Mode This section Activation from Ready-Mode Ready ModeMaximum allowable no-stop time at that depth Surface Mode Activation from Surface ModeIncrease Time Decrease Time Planning a Decompression Dive Step Pre-Dive Planning Mode Page Care During the Dive Care Before the DiveCare & Maintenance Replacing the Battery Operating TemperaturePage Operational Performance No-Decompression Model Technical SpecificationsZH-L8 ADT Calculation Model Workload and TemperatureSummary