A&D 2 Plus owner manual Step

Page 54

STEP 3

When you reach the desired dive time, release the contacts and, after a few moments, the Monitor 3 Air will display the new decompres- sion information. You can then, as shown in step 2, increase and decrease the dive time as you wish.

Note: If there is no activity during the Pre-Dive Planning Mode for three minutes, the Monitor 3 Air automatically returns to Surface Mode or Ready Mode.

STEP 4

Section 4: Pre-Dive Planning Mode

To return to the pre-dive scrolling, touch contacts A & D. If you want to return to Surface Mode or Ready Mode, touch contacts A & D for about three seconds.

WARNING: If two or more divers using computers are planning a dive, planning for all divers must be based on the dive computer showing the shortest no-stop times. Failure to do this may lead to serious injury or death from decom- pression sickness.

47

Image 54 A&D 2 Plus owner manual Step
Contents Page Copyright Notice Safety Considerations Guidelines for Using the Monitor 3 Air Page Table of Contents Memory Mode Page What is a Dive Computer IntroductionIntroduction Features of the Monitor 3 Air Computer ScreenMonitor 3 Air display zones and contact letter designations Transmitter This section Attaching the Transmitter to Your Regulator StepPairing the Wrist Unit to the Transmitter Preparation Preparation Using the Monitor 3 Air Without the Transmitter Checking the Battery PowerThis section Preparation for the Dive Diving with the Monitor 3 Air Functions During the Dive Current DepthDive Time Maximum DepthAscent Rate Ascent Rate DisplayNo-Stop Time Antenna Symbol No-stop time at Minutes remainingGraphic Air Time Remaining ATR Digital Air Time Remaining ATRHigh Air Consumption Warning Decompression Stop Information SOS Mode Total Ascent TimeSurface Mode Surface mode icon Functions at the SurfaceUpon surfacing Wait-to-fly Time Wait-to-fly RecommendationsDesaturation Time Surface Interval TimeMicrobubble Warning Diving at Altitude Altitude sectorsExceeding the Altitude Limit Summary of Attention Messages and Alarms Altitude diveLost transmission after 40 seconds Alarms Low computer battery Activating Memory Mode Scrolling through logged dives Overview Downloading the Memory to a PCMemory Mode From Ready Mode or Surface Mode, touch ActivationExiting Memory Mode Scrolling through Logged DivesMemory Mode This section Ready Mode Activation from Ready-ModeMaximum allowable no-stop time at that depth Activation from Surface Mode Surface ModeIncrease Time Decrease Time Planning a Decompression Dive Step Pre-Dive Planning Mode Page Care Before the Dive Care During the DiveCare & Maintenance Operating Temperature Replacing the BatteryPage Technical Specifications Operational Performance No-Decompression ModelWorkload and Temperature ZH-L8 ADT Calculation ModelSummary