Disassembly/Reassembly, and Adjustment (cont)
Step 4 - Shroud
Disassembly
Note: Make sure the cog release pivot joints are in a posi- tion that matches the shroud cutout.
a.Use a #2 Phillips screw driver to remove the four mount- ing screws and slide out while lifting off the top shroud from the back of the chair.
(figure s4.1).
b.Use a #2 phillips screw driver to remove the six mount- ing screws on the inside of the shroud to remove the side shroud fairing (figure s4.2)
c.Lift the color side shrouds from the side shroud fairing. Note: Color side shrouds are attached using a hook and loop fastener system.
Reassembly
a. Perform the reverse of instructions above.
Note: Remember short screws to rear and middle holes and long screws to front.
s4.1
s4.2
SUNRISE MEDICAL | ASPIRE SERVICE MANUAL | 2003 | PAGE 13 |