FRONT RIGGINGS | SECTION 3 |
Section 3 - Front Riggings includes the following:
Installing/Removing the Footrest
Footrest Height Adjustment
Heel Loop Replacement
Elevating Legrest Assembly Installation
Adjusting the Elevating Legrest Assembly
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
INSTALLING/REMOVING THE FOOTREST (FIGURE 1)
NOTE: This procedure applies to the swingaway footrest and the elevating legrest.
FRONT RIGGINGS
INSTALLING
1.Turn the swingaway footrest assembly to the side (open footplate is perpen- dicular to wheelchair).
2.Install the hinge plates on the swing- away footrest assembly onto the hinge pins on the wheelchair frame.
3.Push the swingaway footrest assembly towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4.Repeat this procedure for the other footrest assembly.
Footrest Release Lever
| Swingaway | |
| Footrest | |
| Assembly | |
| Footplate | |
Hinge Pins | Hinge | |
Plates | ||
|
NOTE: Swingaway footrest shown.
FIGURE 1 - INSTALLING/REMOVING
THE SWINGAWAY FOOTREST
5.To release the footrest, push the footrest release lever inward, rotate footrest outward.
REMOVING
1.Push the footrest release lever inward
2.Rotate swingaway footrest assembly outward.
3.Lift the swingaway footrest assembly off of the hinge pins.
Part No. 1110550 | 23 | Tracer® SX5 |