Part No. 1110550
49
2. While pressing in the armrest release button, remove the armrest from the arm sockets by pulling straight up.
FIGURE 5 - REMOVING OR
INSTALLING ARMRESTREPLACING ARMREST NOTE: Rear armrest release lever must be in the unlocked position when installing the armrest.
1. Position the armrest just above the front and rear arm sockets.
2. Push arm down evenly at the front and rear until the front armrest release button snaps into the front arm socket.
3. Lock rear armrest by turning the armrest release lever towards the back of the wheelchair.
4. Ensure armrest is locked securely in the arm sockets by gently lifting up. If not locked, repeat STEPS 1-3.
1. Press IN the armrest release buttons at the front of the armrest.
Arm Socket
1. Unlock the rear armrest by rotating the armrest release lever towards the outside of the wheelchair.
Armrest Release Lever
WARNING
Make sure the armrest is securely locked BEFORE using the wheelchair.
REMOVING ARMREST
2. Insert lock tube into the handle of the back cane.
3. Ensure the release button fully protrudes out of the hole in the back cane handle.
4. Repeat STEPS 1-3 on opposite end of spreader bar.
REMOVING AND INSTALLING ARMREST (FIGURE 5)
RECLINER | SECTION 10 |
|
|
REMOVING/INSTALLING THE SPREADER BAR (FIGURE 4)
WARNING
Make sure both release buttons of the spreader bar fully protrude out through the holes in the handle BEFORE using the wheelchair.
REMOVING
1.Push in release button on one side of existing spreader bar.
2.While holding spreader bar, pull the lock tube until the release button is out of the handle of the back cane.
3.Drop the spreader bar to one side.
4.Repeat STEPS
INSTALLING
1.Push in release button on one of the lock tubes of the new/existing spreader bar.
Back Cane
Spreader Bar
Handle |
|
Release Button | Lock Tube |
|
FIGURE 4 - REMOVING/
INSTALLING THE SPREADER BAR
RECLINER
Armrest | Armrest |
| Release |
| Button |
Arm Socket |
|