Invacare SX5 Recliner manual Locations, Label

LABEL LOCATIONS

LABEL LOCATIONS

	MODELS WITH
LOCATIONS	QUICK-RELEASE
	AXLES ONLY
	WARNING
	DETENT BALLS MUST BE SECURE-
	LY SEATED IN RECESSED AREAS
	OF AXLE BUSHINGS. ENSURE
LABEL
	THAT PLUNGER PIN IN HEAD END
	OF AXLE IS FULLY RELEASED.
	KEEP DETENT BALLS CLEAN.
	1001948

IMPORTANT NOTICE

The wheel locks on this wheelchair have been pre-set at the factory to comply with the Veterans Administration functional Standard 8320.01 of the Federal Register, paragraph

3.2.4.5.3.If these wheel locks do not meet your needs, follow instructions below.

!CAUTION

Any wheel lock adjustments should embed wheel lock shoe at least 1/8" into tire when locked (3/16" on pneumatic tires).

INSTRUCTIONS FOR WHEEL

LOCK ADJUSTMENTS

1.Loosen wheel lock mounting fastener, which runs through mounting bracket and frame.

2.Slide clamp toward rear wheel until wheel lock shoe is embedded into tire material at least 1/8" when handle is engaged to the lock position (3/16" for pneumatic tires).

3.Tighten mounting fastener to secure mounting bracket in desired location and recheck lock shoe embedding.

4.Inspect for correct locking action BEFORE actual use.

00078X021-0394

WARNING

Refer to Owner's Manual for proper anti-tipper

setting.1085379

	WARNING
DO NOT OPERATE WITHOUT
	THE ANTI-TIP TUBES
REV. 5/98	INSTALLED. P/N 60106X144

14 TO 18-INCH

WIDE

WHEELCHAIRS

(ONLY)

Crossmember

Lower Frame

Tube

20 TO 22-INCH

WIDE

WHEELCHAIRS

(ONLY)

RECLINER MODELS ONLY
	WARNING
DO NOT OPERATE WITHOUT
	THE ANTI-TIP TUBES
REV. 5/98	INSTALLED. P/N 60106X144

Tracer® SX5 6 Part No. 1110550