Invacare SX5 Replacing the Headrest Pillow Figure, Replacing the HEADREST/BACK Upholstery Figure

Page 48
FIGURE 2 - REPLACING THE
HEADREST PILLOW

SECTION 10

RECLINER

REPLACING THE HEADREST PILLOW (FIGURE 2)

RECLINER

1.Unfasten straps of headrest pillow from behind headrest upholstery.

2.Remove existing headrest pillow from headrest.

3.Center new/existing headrest pillow onto the front of the headrest upholstery.

4.Pull straps of new/existing headrest pillow around the back canes.

Fastening

Headrest Upholstery

Strap

Strips

 

 

Strap

Headrest Pillow

5.Pressing firmly, attach the fastening strips

of the new/existing headrest pillow to the fastening strips on the back of the headrest upholstery.

REPLACING THE HEADREST/BACK UPHOLSTERY (FIGURE 3)

HEADREST UPHOLSTERY

1.Remove the headrest pillow. Refer to

REPLACING THE HEADREST PILLOW in this section of the manual.

2.Remove the six (6) mounting screws that secure the headrest upholstery to the headrest extension tubes.

3.Secure NEW headrest upholstery onto headrest extension tubes with the existing six (6) mounting screws.

4.Install headrest pillow. Refer to REPLAC- ING THE HEADREST PILLOW in this section of the manual.

BACK UPHOLSTERY

1.Disengage one (1) side of the spreader bar. Refer to REMOVING/INSTALLING THE SPREADER BAR in this section of the manual.

Headrest Upholstery

Mounting

Headrest

Screws

 

Extension

 

Tube

Back

 

 

Upholstery

Back

Mounting

Cane

Screws

FIGURE 3 - REPLACING THE

HEADREST/BACK UPHOLSTERY

NOTE: To remove and install the bottom two (2) mounting screws of the back upholstery the wheelchair must be partially folded. Refer to SAFETY/HANDLING OF WHEELCHAIRS in SECTION 1 of this manual

2.Remove the twelve (12) mounting screws that secure the back upholstery to the back canes.

3.Secure NEW back upholstery to back canes with the existing twelve (12) mounting screws. Securely tighten.

4.Reengage spreader bar. Refer to REMOVING/INSTALLING THE SPREADER BAR in this procedure of the manual.

Tracer® SX5

48

Part No. 1110550

Image 48
Contents Tracer R SX5 Tracer R SX5 Recliner Tracer SX5 Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLocations LabelSpecifications SpecificationsInformation for Healthcare PROFESSIONALS/ Assistants General GuidelinesSection General Guidelines To Healthcare PROFESSIONALS/ASSISTANTSStability ALL Models Stability NON-RECLINER Models onlyGeneral Guidelines Section Stability Recliner Models only Operating InformationGeneral Guidelines Weight Training Weight LimitationWidth Weight Tire PressureSAFETY/HANDLING of Wheelchairs Stability and BalanceCoping with Everyday Obstacles Percentage of Weight Distribution Tipping Do not tip the wheelchair without assistanceMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeMethod 2 Wheelchair Without Step Tube Stairways ESCALATORS? SorryTransferring to and from Other Seats Unfolding and Folding the WheelchairUnfoldingfolding Tracer SX5 Recliner onlySafety Inspection Checklist Safety InspectionSection Safety Inspection Troubleshooting MaintenanceMaintenance Safety Precautions Suggested Maintenance ProceduresSafety Inspection INSTALLING/REMOVING the Footrest Figure InstallingRemoving Front Riggings SectionFootrest Height Adjustment Figure Heel Loop Replacement FigureRAISING/LOWERING the Elevating Legrest Assembly Figure Adjusting the Elevating Legrest AssemblyUsing or Replacing FLIP-BACK Armrest Figure UsingReplacing ArmsAdjusting Armrest Height Figure Arms SectionInstalling the Back Canes Figure Seat BackandSection Seat and Back InsideReplacing Back Upholstery Figure Replacing Seat Upholstery FigureSeat and Back Section Seat and BackAdjusting Seat Depth Figure Adjusting Seat DepthAdjusting the Seat Width Figure Pivot LinkDetail Detail BREMOVING/INSTALLING the Rear Wheels Permanent Axles FigureRear Wheels Section Rear WheelsDetail a Locking Pins Detent PIN QUICK-RELEASE Axles FigureWheelsrear Section Rear WheelsAdjusting the QUICK-RELEASE Axle Figure Adjusting the QUICK-RELEASE AxleREPLACING/REPAIRING Rear Wheel TIRE/TUBE Replacing Rear Wheel Handrim FigureINSTALLING/REPLACING Fork Assemblies Figure Front Casters SectionFront Casters NON-RECLINER Wheelchairs Under 20-INCHES WideAdjusting Forks Figure CastersfrontSection Front Casters REPLACING/REPAIRING Front Caster TIRE/TUBE Replacing Front Casters FigureINSTALLING/ADJUSTING the ANTI-TIPPERS Installing the ANTI-TIPPERS Figures 1Anti LOCKSTIPPERS/WHEEL Section ANTI-TIPPERS/WHEEL LocksAdjusting the ANTI-TIPPERS Figure ANTI-TIPPERS/WHEEL Locks SectionLocks Wheel Lock Adjustmentfigure Wheel Locks are not BrakesDetail a Wheel Lock Shoe Changing SEAT-TO-FLOOR Height Figures 1 SEAT-TO-FLOOR Height SectionADULT/HEMI Frame Style Figure Recliner Frame Style Figure SEAT-TO-FLOOR HeightTo Heightfloor Seat Section SEAT-TO-FLOOR HeightInch Front Casters Inch Front CastersRear Wheel Mounting Position Tracer SX Recliner Frame Style Inch Fork Mounting PositionsRecliner Operation Figure ReclinerSection Recliner Recliner Section Recliner OperationReplacing the Headrest Pillow Figure Replacing the HEADREST/BACK Upholstery FigureHeadrest Upholstery Back UpholsteryREMOVING/INSTALLING the Spreader BAR Figure Removing Installing the Spreader BARREMOVING/INSTALLING the Rear Wheels Figure REMOVING/INSTALLING the Rear WheelsOptions Section Adult RightAdult Left Rear ViewInstalling the Seat Positioning Strap Figure Section OptionsInstalling the Crutch and Cane Carrier Figure Installing the Crutch and Cane CarrierInstalling the Telescoping I.V. ROD Figure Installing the Telescoping I.V. RODRepositioning the Upper Attachment Right Side Detail a Repositioning the Upper AttachmentLimited Warranty Made in Mexico
Related manuals
Manual 30 pages 6.48 Kb