Invacare SX5 Recliner manual Stability ALL Models, Stability NON-RECLINER Models only

Page 9

GENERAL GUIDELINES

SECTION 1

STABILITY - ALL MODELS

WARNING

The seat depth, size/position of the front casters, size/position of the rear wheels, use of an anti-tipper model, as well as the user condition directly relate to the stability of the wheelchair. Any change to one (1) or any combination of the seven (7) may cause the wheelchair to decrease in stability. These adjustments MUST be performed by a qualified techni- cian.

 

Seat Depth

Caster Size

Caster Position

Wheel Size

Wheel Position

Anti-Tippers

User Condition

 

 

 

 

 

 

 

 

Seat Depth

N/A

 

 

 

 

 

 

 

 

Caster Size

N/A

 

 

 

 

 

 

 

 

Caster Position

N/A

 

 

 

 

 

 

 

 

Wheel Size

N/A

 

 

 

 

 

 

 

 

Wheel Position

N/A

 

 

 

 

 

 

 

 

User Condition

NOTE: When changes to the left hand column occur, follow across the chart and refer to the

procedure that is checked () to maintain the proper stability, safety and handling of the wheelchair.

Seat-to-floor heights have specific positions depending on rear wheel size, rear wheel position, front caster size and front caster position. These adjustments MUST be performed by a qualified technician.

Anti-tippers are specific to the different seat-to-floor heights. Refer to the chart in INSTALLING/ADJUSTING THE ANTI-TIPPERS in SECTION 8 of this manual for correct usage and adjustment. If these requirements cannot be achieved, do not use the wheelchair. Contact a qualified technician.

If changing the seat-to-floor height the correct anti-tippers MUST be ordered to maintain a 1-1/2 to 2-inch ground clearance.

Anti-tippers MUST be fully engaged. Ensure that the release button of the anti-tipper fully protrudes out of the hole on the bottom of the wheel- chair frame.

Ensure both anti-tippers are adjusted to the same height.

STABILITY - NON-RECLINER MODELS ONLY

WARNING

Anti-tippers MUST BE attached at all times. Inasmuch as the anti-tippers are an option on this wheelchair (you may order with or without the anti- tippers), Invacare strongly recommends ordering the anti-tippers as an additional safeguard for the wheelchair user.

GENERAL GUIDELINES

Part No. 1110550

9

Tracer® SX5

Image 9
Contents Tracer R SX5 Tracer R SX5 Recliner Tracer SX5 Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLabel LocationsSpecifications SpecificationsGeneral Guidelines Information for Healthcare PROFESSIONALS/ AssistantsSection General Guidelines To Healthcare PROFESSIONALS/ASSISTANTSStability ALL Models Stability NON-RECLINER Models onlyGeneral Guidelines Section Operating Information Stability Recliner Models onlyGeneral Guidelines Weight Limitation Weight TrainingWidth Weight Tire PressureSAFETY/HANDLING of Wheelchairs Stability and BalanceCoping with Everyday Obstacles Percentage of Weight Distribution Do not tip the wheelchair without assistance TippingMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeMethod 2 Wheelchair Without Step Tube ESCALATORS? Sorry StairwaysUnfolding and Folding the Wheelchair Transferring to and from Other SeatsTracer SX5 Recliner only UnfoldingfoldingSafety Inspection Checklist Safety InspectionSection Safety Inspection Maintenance TroubleshootingMaintenance Safety Precautions Suggested Maintenance ProceduresSafety Inspection Installing INSTALLING/REMOVING the Footrest FigureRemoving Front Riggings SectionHeel Loop Replacement Figure Footrest Height Adjustment FigureAdjusting the Elevating Legrest Assembly RAISING/LOWERING the Elevating Legrest Assembly FigureUsing Using or Replacing FLIP-BACK Armrest FigureReplacing ArmsArms Section Adjusting Armrest Height FigureSeat Backand Installing the Back Canes FigureSection Seat and Back InsideReplacing Seat Upholstery Figure Replacing Back Upholstery FigureSeat and Back Section Seat and BackAdjusting Seat Depth Adjusting Seat Depth FigurePivot Link Adjusting the Seat Width FigureDetail B DetailPermanent Axles Figure REMOVING/INSTALLING the Rear WheelsRear Wheels Section Rear WheelsQUICK-RELEASE Axles Figure Detail a Locking Pins Detent PINWheelsrear Section Rear WheelsAdjusting the QUICK-RELEASE Axle Adjusting the QUICK-RELEASE Axle FigureReplacing Rear Wheel Handrim Figure REPLACING/REPAIRING Rear Wheel TIRE/TUBEFront Casters Section INSTALLING/REPLACING Fork Assemblies FigureFront Casters NON-RECLINER Wheelchairs Under 20-INCHES WideAdjusting Forks Figure CastersfrontSection Front Casters Replacing Front Casters Figure REPLACING/REPAIRING Front Caster TIRE/TUBEInstalling the ANTI-TIPPERS Figures 1 INSTALLING/ADJUSTING the ANTI-TIPPERSAnti LOCKSTIPPERS/WHEEL Section ANTI-TIPPERS/WHEEL LocksAdjusting the ANTI-TIPPERS Figure ANTI-TIPPERS/WHEEL Locks SectionLocks Wheel Lock Adjustmentfigure Wheel Locks are not BrakesDetail a Wheel Lock Shoe SEAT-TO-FLOOR Height Section Changing SEAT-TO-FLOOR Height Figures 1ADULT/HEMI Frame Style Figure Recliner Frame Style Figure SEAT-TO-FLOOR HeightSection SEAT-TO-FLOOR Height To Heightfloor SeatInch Front Casters Inch Front CastersInch Fork Mounting Positions Rear Wheel Mounting Position Tracer SX Recliner Frame StyleRecliner Operation Figure ReclinerSection Recliner Recliner Operation Recliner SectionReplacing the HEADREST/BACK Upholstery Figure Replacing the Headrest Pillow FigureHeadrest Upholstery Back UpholsteryRemoving Installing the Spreader BAR REMOVING/INSTALLING the Spreader BAR FigureREMOVING/INSTALLING the Rear Wheels REMOVING/INSTALLING the Rear Wheels FigureAdult Right Options SectionAdult Left Rear ViewSection Options Installing the Seat Positioning Strap FigureInstalling the Crutch and Cane Carrier Installing the Crutch and Cane Carrier FigureInstalling the Telescoping I.V. ROD Figure Installing the Telescoping I.V. RODRepositioning the Upper Attachment Detail a Repositioning the Upper Attachment Right SideMade in Mexico Limited Warranty
Related manuals
Manual 30 pages 6.48 Kb