Invacare SX5 Recliner manual Footrest Height Adjustment Figure, Heel Loop Replacement Figure

Page 24

FRONT RIGGINGS

SECTION 3FRONT RIGGINGS

FOOTREST HEIGHT ADJUSTMENT (FIGURE 2)

NOTE: This procedure applies to the swingaway

 

Upper Footrest Support

footrest and eleveating legrest.

 

Release Button

1. Remove the swingaway footrest

 

Adjustment

 

assembly. Refer to INSTALLING/

Lower Footrest Assembly

Holes

REMOVING THE SWINGAWAY

 

FOOTREST in this section of the

Cam Lock

manual.

Lever

NOTE: Lay the assembly on a flat surface to

NOTE: Swingaway footrest shown.

simplify this procedure.

FIGURE 2 - SWINGAWAY

2. Pull the cam lock lever to UP (UN-

FOOTREST HEIGHT

LOCKED) position.

ADJUSTMENT

 

3.Push IN the release buttons and

reposition the lower footrest assembly to the desired height.

4.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.

5.Rotate cam lock lever DOWN to LOCKED position.

6.Repeat this procedure for the other footrest, if necessary.

7.Reinstall the swingaway footrest assembly. Refer to INSTALLING/REMOVING THE SWINGAWAY FOOTREST in this section of the manual.

HEEL LOOP REPLACEMENT (FIGURE 3)

1.

Pull the cam lock lever to UP (UN-

Mounting Screw

 

LOCKED) position.

 

Cam Lock Lever

 

 

 

2.

Push IN the release buttons and re-

Spacer

 

 

move the lower footrest assembly.

Heel Loop

 

 

3.

Remove the mounting screw, spacer

 

Slide Tube

 

and locknut that secure the heel loop

 

 

 

to the footrest.

 

Lower

4.

Remove EXISTING heel loop from

Locknut

Footrest

 

slide tube.

 

Assembly

5.

Install NEW heel loop onto slide tube.

 

Footrest

FIGURE 3 - HEEL LOOP

6.

Install the mounting screw, spacer and

 

REPLACEMENT

 

locknut to secure the heel loop to the

 

 

 

 

footrest. Tighten until the spacer is secure.

7.Insert the lower footrest assembly into the upper footrest assembly to desired height.

8.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.

9.Rotate cam lock lever DOWN to LOCKED position.

Tracer® SX5

24

Part No. 1110550

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Tracer R SX5 Tracer R SX5 Recliner Tracer SX5 Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLocations LabelSpecifications SpecificationsInformation for Healthcare PROFESSIONALS/ Assistants General GuidelinesSection General Guidelines To Healthcare PROFESSIONALS/ASSISTANTSStability ALL Models Stability NON-RECLINER Models onlyGeneral Guidelines Section Stability Recliner Models only Operating InformationGeneral Guidelines Weight Training Weight LimitationWidth Weight Tire PressureSAFETY/HANDLING of Wheelchairs Stability and BalanceCoping with Everyday Obstacles Percentage of Weight Distribution Tipping Do not tip the wheelchair without assistanceMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeMethod 2 Wheelchair Without Step Tube Stairways ESCALATORS? SorryTransferring to and from Other Seats Unfolding and Folding the WheelchairUnfoldingfolding Tracer SX5 Recliner onlySafety Inspection Checklist Safety InspectionSection Safety Inspection Troubleshooting MaintenanceMaintenance Safety Precautions Suggested Maintenance ProceduresSafety Inspection INSTALLING/REMOVING the Footrest Figure InstallingRemoving Front Riggings SectionFootrest Height Adjustment Figure Heel Loop Replacement FigureRAISING/LOWERING the Elevating Legrest Assembly Figure Adjusting the Elevating Legrest AssemblyUsing or Replacing FLIP-BACK Armrest Figure UsingReplacing ArmsAdjusting Armrest Height Figure Arms SectionInstalling the Back Canes Figure Seat BackandSection Seat and Back InsideReplacing Back Upholstery Figure Replacing Seat Upholstery FigureSeat and Back Section Seat and BackAdjusting Seat Depth Figure Adjusting Seat DepthAdjusting the Seat Width Figure Pivot LinkDetail Detail BREMOVING/INSTALLING the Rear Wheels Permanent Axles FigureRear Wheels Section Rear WheelsDetail a Locking Pins Detent PIN QUICK-RELEASE Axles FigureWheelsrear Section Rear WheelsAdjusting the QUICK-RELEASE Axle Figure Adjusting the QUICK-RELEASE AxleREPLACING/REPAIRING Rear Wheel TIRE/TUBE Replacing Rear Wheel Handrim FigureINSTALLING/REPLACING Fork Assemblies Figure Front Casters SectionFront Casters NON-RECLINER Wheelchairs Under 20-INCHES WideAdjusting Forks Figure CastersfrontSection Front Casters REPLACING/REPAIRING Front Caster TIRE/TUBE Replacing Front Casters FigureINSTALLING/ADJUSTING the ANTI-TIPPERS Installing the ANTI-TIPPERS Figures 1Anti LOCKSTIPPERS/WHEEL Section ANTI-TIPPERS/WHEEL LocksAdjusting the ANTI-TIPPERS Figure ANTI-TIPPERS/WHEEL Locks SectionLocks Wheel Lock Adjustmentfigure Wheel Locks are not BrakesDetail a Wheel Lock Shoe Changing SEAT-TO-FLOOR Height Figures 1 SEAT-TO-FLOOR Height SectionADULT/HEMI Frame Style Figure Recliner Frame Style Figure SEAT-TO-FLOOR HeightTo Heightfloor Seat Section SEAT-TO-FLOOR HeightInch Front Casters Inch Front CastersRear Wheel Mounting Position Tracer SX Recliner Frame Style Inch Fork Mounting PositionsRecliner Operation Figure ReclinerSection Recliner Recliner Section Recliner OperationReplacing the Headrest Pillow Figure Replacing the HEADREST/BACK Upholstery FigureHeadrest Upholstery Back UpholsteryREMOVING/INSTALLING the Spreader BAR Figure Removing Installing the Spreader BARREMOVING/INSTALLING the Rear Wheels Figure REMOVING/INSTALLING the Rear WheelsOptions Section Adult RightAdult Left Rear ViewInstalling the Seat Positioning Strap Figure Section OptionsInstalling the Crutch and Cane Carrier Figure Installing the Crutch and Cane CarrierInstalling the Telescoping I.V. ROD Figure Installing the Telescoping I.V. RODRepositioning the Upper Attachment Right Side Detail a Repositioning the Upper AttachmentLimited Warranty Made in Mexico
Related manuals
Manual 30 pages 6.48 Kb
Top Page Image Contents