SEAT BACKAND
SECTION 5 | SEAT AND BACK | |
|
|
|
ADJUSTING SEAT DEPTH (FIGURE 4)
WARNING
The seat depth, size/position of the front casters, size/position of the rear wheels, use of an
1.Remove the existing seat upholstery from the wheelchair. Refer to REPLACING SEAT UPHOLSTERY in this section of the manual.
NOTE: If adjusting the seat depth of the wheelchair, the seat upholstery MUST be changed as well.
2.Remove the two (2) plug buttons from the ends of the crossbraces that are towards the front of the wheelchair.
NOTE: The two (2) plug buttons will be used in the ends of the seat extensions.
3.Install the two (2) seat extension tubes into the ends on the crossbraces. Line up the rear mounting hole of the seat extension tube with the second mounting hole from the end of the crossbrace.
4.Install the two (2) seat extension spacers onto the two (2) seat extension tubes.
5.Install the new seat upholstery onto the wheelchair. Make sure to line up the mounting holes in the seat extension tubes and seat extension spacers with the new seat upholstery. Refer to REPLACING SEAT UPHOLSTERY in this section of the manual.
6.Install plug buttons into the ends of the seat extension spacers.
Phillips Screws
Seat Extension
Spacer
Seat Upholstery
Crossbrace
SECOND Mounting Hole From End
Plug Button | REAR Mounting Hole |
| |
| Seat Extension Tube |
FIGURE 4 - ADJUSTING SEAT DEPTH
Tracer® SX5 | 30 | Part No. 1110550 |