Invacare Pronto R2 Replacing Heel Loops Figure, INSTALLING/REMOVING Elevating Legrests Figure

PROCEDURE 3 FRONT RIGGINGS

F R O N T

R

I

G G I N G S

Footrest Support

Locknut

Coved

Washer

Hex Bolt

Coved Washer

NOTE: PW93ST style	Lower Footrest
footrest shown for clarity
only.

FIGURE 2 - ADJUSTING FOOTREST HEIGHT - ALL FOOTRESTS EXCEPT MODEL P93M FOOTRESTS

P93M Model Footrests (FIGURE 3)

1.Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support.

2.Reposition the lower footrest to the desired height.

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1-3 for the opposite side of the wheel-

chair footrest, if necessary.

Lug Bolt

Footrest

Support

Locknut	Lower
	Footrest

FIGURE 3 - ADJUSTING FOOTREST HEIGHT - P93M

MODEL FOOTRESTS

REPLACING HEEL LOOPS (FIGURE 4)

1.Note the position of the hex bolt, coved washers and locknut for reinstallation.

2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

3.Remove the lower footrest.

4.Remove the phillips bolt, spacer and locknut that se- cure the existing heel loop to the lower footrest.

5.Slide the existing heel loop off the lower footrest.

6.Replace heel loop.

7.Reverse STEPS 1-6 to reassemble.

NOTE: When securing the heel loop to the lower footrest, tighten the phillips screw and locknut until spacer is secure.

Footrest Support

Locknut	Hex Bolt
Cover Washers	Phillips Bolt
	Spacer
Lower Footrest	Heel Loop
	Locknut
FIGURE 4 - REPLACING HEEL LOOPS

INSTALLING/REMOVING ELEVATING LEGRESTS (FIGURE 5)

Installing

1.Turn the legrest to the side (open footplate is perpen- dicular to wheelchair) and position the mounting holes in the legrest hinge plates with the hinge pins on the wheelchair frame.

2.Install the legrest hinge plates onto the hinge pins on the wheelchair frame.

3.Rotate legrest toward the inside of the wheelchair until it locks in place.

NOTE: The footplate will be on the inside of the wheel- chair when locked in place.

4.Repeat STEPS 1-3 for the opposite legrest.

5.Afterseatedinwheelchair,adjustfootplatetocorrectheight by loosening the nut and sliding the lower footrest as- sembly up or down until desired height is achieved.

Removing

1.Push the legrest release handle toward the inside of the wheelchair (facing the front of the wheelchair) and swing the legrest to the outside of the wheelchair.

2.Lift up on the legrest and remove from the wheelchair.

3.Repeat STEPS 1-2 for the opposite side of the wheel- chair.

Legrest Release Handle

		Lower
Hinge		Footrest
Pins		Assem-
		bly
Wheelchair	Legrest	Nut
Frame	Hinge

Plates

FIGURE 5- INSTALLING/REMOVING ELEVATING LEGRESTS

16