Invacare Pronto R2, R2-250 Locknut Caplug Washer, Hub Cap, Adjusting the Calf-Pad Width Figure

F R O N T

R

I

G G I N G S

PROCEDURE 3			FRONT RIGGINGS
	Mounting		CAUTION
Warning	Bolt	Hub Cap	DO NOT use outside mounting slots, otherwise
Label			damage to the calf-pads may occur.
Large Washer			Calf-Pad
Locknut		Caplug
		Washer
		Large	Phillips Head
		Washer
Hub Cap			Screws and
		Pivot Bracket
			Washers
Caplug			Calf-Pad
Washer		Footboard	Bracket
NOTE: Calf-pads not shown for clarity.			FIGURE 18 - ADJUSTING THE CALF-PAD WIDTH
FIGURE 17 - ADJUSTING THE CALF-PAD HEIGHT

Adjusting the Calf-Pad Width (FIGURE 18)

1.Loosen, DO NOT remove the two (2) phillips head screws and washers that secure the calf-pad to the calf-pad bracket.

2.Slide the calf-pad left or right until the desired width is achieved.

CAUTION

Calf pad width adjustment may be limited by other chair components. Ensure calf pad will clear full up and down travel of front stabilizer assemblies. Otherwise, damage to the calf pad may result.

3.Tighten the two (2) phillips head screws and wash- ers that secure the calf-pads to the calf-pad bracket.

4.Repeat STEPS 1-3 for opposite side if necessary.

5.If necessary, replace the one piece footboard. Re- fer to INSTALLING THE ONE PIECE FOOTBOARD in this procedure of the manual.

Adjusting the Calf Pad Angle (FIGURE 19)

1.Loosen, DO NOT remove, the two (2) mounting screws and locknuts that secure the calf-pad bracket to the pivot bracket.

2.Rotate the calf-pad to the desired angle.

3.Securely tighten the two (2) mounting screws and locknuts that secure the calf-pad bracket to the calf bracket.

4.Repeat STEPS 1-3 for opposite calf-pad if neces- sary.

Calf-Pad

Bracket

Calf-Pad

Mounting Screws

and Locknuts

Pivot Bracket

FIGURE 19 - ADJUSTING THE CALF-PAD ANGLE

22