Invacare R2-250, Pronto R2 manual REMOVING/INSTALLING Shrouds Figure, R O U D S

SHROUDS PROCEDURE 9

This Procedure Includes the Following:

Removing/Installing Shrouds

WARNING

After ANY adjustments, repair or service and BE- FORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

REMOVING/INSTALLING SHROUDS (FIGURE 1)

Removing Rear Shroud and Rear Storage Compartment

NOTE: The rear storage compartment is available on wheelchairs NOT equipped with weight shift basic tilt only.

1.Lift up on rear shroud and remove from wheelchair.

2.Turn the two (2) 1/4-turn bolts that secure the rear storage compartment to the wheelchair frame COUN-

TERCLOCKWISE.

3.Remove rear storage compartment from wheelchair.

S H R O U D S

Removing Front Shroud

1.Turn the two (2) 1/4-turn bolts that secure front shroud to the two (2) side shrouds COUNTERCLOCKWISE.

2.Remove the front shroud from the wheelchair.

Installing Front Shroud

1.Position the two (2) 1/4-turn bolts with the two (2) mounting holes in the side shrouds.

2.Install the front shroud onto the two (2) side shrouds.

3.Turn the two (2) 1/4-turn bolts that secure the front shroud to the two (2) side shrouds CLOCKWISE.

Installing Rear Shroud and Rear Storage Compartment

1.Position the two (2) 1/4-turn bolts with the two (2) mounting holes in the wheelchair frame.

2.Install rear storage compartment onto chair frame.

3.Turn two (2) 1/4-turn bolts that secure the rear stor- age compartment to the wheelchair frame CLOCK- WISE.

4.Position rear shroud on the two (2) side shrouds and slide towards the front of the wheelchair until it stops.

5.Press down on the rear shroud until the two (2) clips secure the rear shroud to the two (2) side shrouds.

Rear Shroud

Wheelchair

Frame

Rear Storage

Compartment

1/4-Turn Bolts

Front Shroud

NOTE: Side shrouds are exploded away for clarity.

There is no need to remove side shrouds.

FIGURE 1 - REMOVING/INSTALLING SHROUDS

35